Heat & Glo LifeStyle 6000TRI, 6000TR-OAK, 6000TRXI User Manual

BURNER REPLACEMENT

Models: 6000TR-OAK, 6000TRI, 6000TRXI

- Installation Instructions -

CAUTION! Risk of Cuts or Abrasions. Wear protective

gloves and safety glasses during installation. Sheet metal
edges are sharp.

KIT CONTENTS:

• Burner Assembly

• Pilot Bracket

• Additional burner neck (not for all models)

1. Remove existing logs, grate and burner.

2. Replace existing pilot bracket with new pilot bracket
The new pilot bracket is 1/4 inch taller.

3. Install new burner.

4. Determine whether or not fi replace is equipped with
slide mechanism shutter assembly that is adjustable
from outside the fi rebox.

• If it is not equipped with this assembly , replace burner

neck on burner assembly with additional burner neck
included with the kit. Remove air shutter from old
burner neck by removing one screw. Reinstall on
new burner neck.

• If it is equipped with the assembly use burner as

supplied with the kit.

5. Install logs according to log placement instructions.

6. Some models are equipped with refractory. Trim
refractory panels to fi t if necessary.

Figure 1

Please contact your Heat & Glo dealer with any questions

or concerns.

For the location of your nearest Heat & Glo dealer,

please visit www.heatnglo.com.

Heat & Glo, a brand of Hearth & Home Technologies Inc.

7571 215th Street West, Lakeville, MN 55044

www.heatnglo.com

Heat & Glo • Burner Replacement Installation Instructions • 2187-901 Rev. E • 2/12

1