Heat & Glo SSF-LUX60-BK Installation Instructions

Installation

Instructions

SSF-LUX60-BK Surround Kit

(Requires the purchase of a set of
SPL-LUX60-BK black powder coated or
SPL-LUX60-BKN black nickel plated “L” Plates)

This surround kit has been tested for use with the Heat & Glo LUX60. Check with your local building code agency before
you begin installation to ensure compliance with local codes, including the need for permits and follow-up inspections. If
you encounter any problems regarding code approvals, or if you need clarifi cation of any of the instructions contained here,
contact your Hearth & Home Technologies Inc. dealer. For the dealer nearest you, please visit www.heatnglo.com.

Note: An arrow (¨) found in the text signifi es change in content.

Inner

Frame

CAUTION! Risk of Cuts, Abrasions or Flying
Debris. Wear protective gloves and safety glasses

during installation. Sheet metal edges are sharp.

This kit contains:

1 Outer Frame

2 Inner Frame with Screen

3 Fastener Pack containing:

Sixteen 5/8 in. Bolts

Outer

Frame

Twelve #8 Self-tapping Screws

Figure 1 SSF-LUX60-BK Surround Kit

Heat & Glo • LUX60 Surround Kit • 4062-202 • Rev A • 03/09

1

• Remove surround frame from packaging. Be very careful
to not cut into the steel frame or scratch the paint. Set
aside.

NOTICE: All fi ngerprints and smudges must be wiped
clean from the viewable surfaces of the surround kit prior
to the initial burning of the fi replace. If this is not done,
these prints and smudges will be cured into the fi nish and
set for the life of the fi replace. To keep the fi nish looking
its best, gently wipe with a soft cloth and if desired, soap
and water. Never use thinner or abrasive cleaners since
these products will damage the fi nish.

CAUTION! The surround kit is heavy. We recommend
two installers to put the frames in place.

• Remove the twelve screws holding the rock templates
(if in place) from the fi replace. Discard the screws and
templates.

Rock

Template

8.44 in.

• Place the bottom tabs of the inner frame into the slots
on the bottom fl ange of the outer frame. Pull the spring
clips (located at the top inside of the inner frame) towards
the center of the frame, rotate the top of the frame to the
fi replace. When the inner frame front is fl ush with the outer
frame front, release the clips to lock the frame in place.

Spring

Clip

Figure 4 Install Inner Frame (shown from the back side)

Fasten with

12 screws

6.81 in.

Figure 2 Remove Rock Templates

• Set the outer frame in place inside the 1 in. square tube
frame on the fi replace. Secure the outer frame fl ange to
the square tube frame with 12 self-tapping screws from
the fastener pack.

1 in. Square
Tube Frame

• Install the “L” plates onto the frame/surround using the
5/8 in. bolts from the fastener pack.

- The “L” plates are interchangeable diagonally from

corner to corner, but not from top to bottom or side to
side.

- Tighten the bolts, taking care to not scratch the powder

coating on the bolt head.

- Do not overtighten the bolts. A snug fi t is enough to

hold the “L” plates in place.

Flange of

Outer Frame

Figure 3 Install Outer Frame

2

Figure 5 Finished

Heat & Glo • LUX60 Surround Kit • 4062-202 • Rev A • 03/09