Heat & Glo Soulstice Halo Surround Installation Instructions

Soulstice Halo Surround

MICORE

HEADER

BRACKET

LOCATION

HOLES

HALO BRACKET

HALO

SURROUND

ASHLIP

FRONT

PANELS

Leave this manual with party
responsible for use and
operation.

WARNING

HOT! DO NOT TOUCH.

SEVERE BURNS MAY RESULT.

CLOTHING IGNITION MAY RESULT.

Glass and other surfaces are hot
during operation and cool down

- Installation Instructions -

Figure 1

• Keep children away.

• CAREFULLY SUPERVISE children in same

• Alert children and adults to hazards of high

• Do NOT operate with protective barriers

• Keep clothing, furniture, draperies and other

• If it does not, contact Hearth & Home

room as appliance.

temperatures.

open or removed.

combustibles away.

CAUTION

Sharp Edges

Wear protective gloves and safety
glasses during installation.

WARNING

Fire Hazard

Fireplace MUST have micore
header and bracket location holes
for safe operation with Halo front.

Technologies at 1-800-669-4328 to obtain a
SOUL-HK kit.

1. After verifying that the Soulstice fireplace has the micore header
and bracket location holes (see Figure 1), remove the front panels
and ashlip (see Figure 2).

Figure 2

2. Carefully attach the Halo brackets to the inside of the fireplace
face with the screws provided. The brackets should be attached
through the bracket location holes at the fireplace opening upper

Printed in U.S.A. • InD • Copyright 2005
Hearth & Home Technologies Inc., 20802 Kensington Boulevard, Lakeville, MN 55044

corners. The studs on the brackets should point inward, towards
the center of the unit (see Figure 2).

2081-905B 8/05

Figure 3

HALO BRACKET

WING NUT

STUD

ASHLIP

PANELS

HALO

SURROUND

3. Position the Halo Surround onto the face of the unit
(see Figure 3). The slots on the inside edges of the
Halo should slide over the studs on the brackets just
installed. The stud on the bottom center of the Halo
will fit through the hole on the fireplace bottom panel.

4. Secure the surround by tightening the provided wing
nuts onto the studs on the two Halo brackets and onto
the stud now protruding through to the inside of the
bottom panel.

5. Replace the ashlip and front panels. It is easiest to

put the left and right panels in first. Place the ash lip
in position last.

6. The hanging mesh assembly (not shown in figure)
should remain in place and be used with the Halo
front.

Service Parts List

Description Part Number

Bracket, Front Surround 2081-196

Inner Door Cap 2081-193

Outer Door Cap 2081-191