Heat & Glo Crescent II Door Installation Instructions

Leave this manual with party responsible for use and operation.

WARNING

HOT! DO NOT TOUCH. SEVERE BURNS MAY RESULT. CLOTHING IGNITION MAY RESULT.

Glass and other surfaces are hot during operation and cool down.

• Keep children away.

• CAREFULLY SUPERVISE children in same room as appliance.

• Alert children and adults to hazards of high temperatures.

• Do NOT operate with protective barriers open or removed.

• Keep clothing, furniture, draperies and other combustibles away.

Crescent II Door

- Installation Instructions -

J-HOOK

BOLT

The door is attached to the appliance with j-hooks.

Door Installation:

To install the door on the fireplace hold the door about 1/8 inch higher than the unit and center over the fireplace. Slowl y lower the door until all four j-hooks are engaged.

Figure 1. Door shown: Reserve

Door Removal:

T o remove the door , raise the door up about 1/8 inch to disengage the j-hooks and pull the door toward you.

Interchangeable Decorative Panels (Essence Doors):

The decorative panel at the bottom of the door is interchangeable with many different options. Contact your dealer or visit www.fireplaces.com for interchangeable panel options.

To change decorative panel:

• Remove the two 3/8 inch nuts on the back of door (see Figure 2).

• Remove the backing plate from the bolts.

• Slide the backing plate into the decorative panel.

• Place the new panel onto the bolts and secure with nuts.

Replacement Parts:

Mesh ............................................................................. 2083-145

Essence Doors Only -

Backing Plate: Pewter, Bronze..................................... 2083-160

Polished Brass ................................ 2083-160PB

Brushed Nickel................................2083-160BN

J-HOOK

NUTS

Figure 2. Door shown: Essence

BACKING PLATE

2083-904B 5/05