Heat & Glo CERONA-42, CERONA-42-IFT Installation Instructions

LOGS-CERONA42

MODELS: CERONA-42, CERONA-42-IFT

Installation Instructions

Leave this manual with party responsible for use
and operation.

CAUTION! Risk of Cuts or Abrasions. Wear protective
gloves and safety glasses during installation.

CAUTION: Logs are fragile, handle with care.

NOTICE: To simplify the installation process, use
Figure 1 to positively identify each individual log
before beginning installation.

Note: Logs may appear di󰀨erent than previous
CERONA-42 logs.

11

55

44

22

33

66

MODEL: CREONA-42, CERONA-42-IFT

LOGS-CERONA42

LOG ID SRV PART #

1 SRV2107-701

2 SRV2107-702

3 SRV2107-703

4 SRV2107-704

5 SRV2107-705

6 SRV2107-706

11

Figure 1

Figure 2

STEP 1. LOG #1 (SRV2107-701):

Place log #1 over the back side of the burner plate and slide forward until log hits the grate. Log cut out should t over pilot

bracket. See Figure 2.

FLAT FLAT

AREAAREA

22

FORM FITTED FORM FITTED

TO GRATE TINETO GRATE TINE

Figure 3

STEP 2. LOG #2 (SRV2107-702):

Fit log #2 on the right side of the grate. The log is formed
so it will sit around the right grate bar. Rest the top of the

log on the at section of log #1. See Figure 3.

Heat & Glo • LOGS-CERONA42 Installation Instructions • 2107-935 Rev. D • 1/21

AA

33

Figure 4

STEP 3. LOG #3 (SRV2107-703):

Place the tip of log #3 over the at area on log #1. Place the

left leg of the log on the far left grate tine (A). See Figure 4.

1

44

NOTCH FITSNOTCH FITS
ON BURNERON BURNER

DETAILDETAIL

NOTCH FITS OVER FRONT GRATE BARNOTCH FITS OVER FRONT GRATE BAR

Figure 5.

55

Figure 6.

STEP 4. LOG #4 (SRV2107-704):

Place the left formed end of log #4 on the burner detail
located under log #3, and the notch on the right end of log
#4 on the front grate bar. Log #3 may need to be adjusted
for proper placement. See Figure 5.

66

Figure 7

STEP 5. LOG #5 (SRV2107-705):

Place log #5 on the left side between the grate tine and
rebox. Note: This log will be used to support log #6.
See Figure 6.

STEP 6. LOG #6 (SRV2107-706):

Place notch of log #6 over the left grate tine. Log should rest on

the at of log #5 and the at on log #3. You may need to reposi­tion log #5 to get log #6 to sit in the ats. See Figure 7.

2

Heat & Glo • LOGS-CERONA42 Installation Instructions • 2107-935 Rev. D • 1/21