Heatcontroller RADS-121G User Manual

Owner’s &
InstructIOn Manual
Room Air Conditioner:
Remote Controller
Hea t C ont rol ler, Inc. • 1900 Wellworth Ave . • Ja cks on, MI 49 203 • (51 7)7 87- 210 0 • ww w.heatcontroller.com
Owner’s Manual Room Air Remote Controller Heat Controller, Inc.
5m
CAUTIONS
The air conditioner will not operate if curtains, doors or other materials block the signals from the remote controller to the indoor unit. Prevent any liquid from falling into the remote controller. Do not expose the remote controller to direct sunlight or heat. If the infrared signal receiver on the indoor unit is exposed to direct sunlight, the air conditioner may not function properly. Us sunlight from falling on the receiver. If other electrical appliances react to the remote controller, either move these appliances or consult your local dealer.
Handling the remote controller
Sleep
CFhiletecrk
FoMlleow
Auto
On/off
Fan
High
Med
Low
ESnaevregry
on off
Timer
Auto
Fan
Cool
Dry
Mode
TEMP/TIMER
TEMP/TIMER
Heat
The remote controller is powed by two dry batteries(R03/LR03X2) housed in the rear part and protected by a cover. (1) Remove the cover by pressing and sliding off. (2) Remove the old batteries and insert the new batteries,placing the(+) and (-) ends correctly. (3) Reattach the cover by sliding it back into position.
NOTE: When the batteries are removed, the remote controller erases all programming. After inserting new batteries, the remote controller must be reprogrammed.
Replacing batteries
CONTENTS
Handling the remote controller ......................................................
Using the remote controller.....
Remote controller Specifications...................................................
Function buttons .................. .........................................................
How to use the buttons .................................................................
Auto operation..........................................................................................................
Cooling/Heating/Health operation...........................................................................
Dehumidifying operation ........................................................................................
Sleep operation.......................................................................................................
Timer operation ......................................................................................................
2
3
4
5
5
5
6
6
7
1
Heat Controller, Inc. Room Air Remote Controller Owner’s Manual
Handling the remote controller
Using the remote controller
TEMP/TIMER
ESnaevregry
Sleep
CFhiletecrk
TEMP/TIMER
FoMlleow
Auto
on off
Cool
Auto
Mode
Dry
High
Fan
On/off
Timer
Heat
Fan
Med
Low
5m
MODE
SPEED
TIMER
SLEEP
ONE TOUCH
Location of the remote controller.
Use the remote controller within a distance
Use the remote controller within a distance of 5
of 16 ft (5m) from the appliance, pointing it
meters from the appliance, pointing it towards
towards the receiver. Reception is conrmed
the receiver. Reception is confirmed by a beep.
by a beep when a button on the remote controller is pressed.
CAUTIONS
The air conditioner will not operate if curtains, doors or other materials block the signals from the remote controller to the indoor unit. Prevent any liquid from falling into the remote controller. Do not expose the
onto
remote controller to direct sunlight or heat. If the infrared signal receiver on the indoor unit is exposed to direct sunlight, the air conditioner may not function properly. Us
e curtains to prevent the sunlight from falling on the receiver. If other electrical appliances react to the remote controller, either move these appliances or consult your local dealer.
Replacing batteries
The remote controller is powed by two dry batteries(R03/LR03X2) housed in the rear
of the remote’s housing and protected by a cover.
part and protected by a cover.
AAA batteries (RO3/LRO3X2) housed in the rear
(1) Remove the cover by pressing and sliding off. (2) Remove the old batteries and insert the new batteries,placing the(+) and (-) ends correctly. (3) Reattach the cover by sliding it back into position.
NOTE: When the batteries are removed, the remote controller erases all programming. After inserting new batteries, the remote controller must be reprogrammed.
2
Loading...
+ 7 hidden pages