Hearth Home COSMO-IFT-B, PHTRIM-32LINEAR, PHTRIM-36LINEAR, PHTRIM-42LINEAR Installation Manual

PHTRIM-32LINEAR, PHTRIM-36LINEAR, PHTRIM-42LINEAR

Models: COSMO-IFT-B Series, RAVE-IFT-B Series, JADE-B Series

DVLINEAR36, B41L-AU

Passive Heat Trim Installation Instructions

Leave this manual with party responsible for use
and operation.

CAUTION! Risk of Cuts, Abrasions or Flying Debris.

Wear protective gloves and safety glasses during instal­lation. Sheet metal edges are sharp.

CAUTION! Do not install damaged components.

If any parts are missing or damaged, contact your dealer before
starting installation. DO NOT install a damaged kit.

DANGER

HOT GLASS WILL

CAUSE BURNS.

DO NOT TOUCH GLASS

UNTIL COOLED.

NEVER ALLOW CHILDREN

TO TOUCH GLASS.

A barrier designed to reduce the risk of
burns from the hot viewing glass is provided
with this appliance and must be installed for
the protection of children and other at-risk
individuals.

Introduction

This trim kit is used with the Passive Heat Front Discharge
(PH-FRT-LINEAR) Heat Management System, which con-

veys warm air from the replace into the same room through

a front discharge opening. Installation of the Passive Heat
kit must be done in conjunction with the appliance installa­tion. Follow instructions included with the PH-FRT-LINEAR
kit to complete installation of the Passive Heat system.
Installation of this kit MUST be performed by a qualied
service technician.

WARNING! Risk of Fire! DO NOT install the Passive Heat
system with models that are not approved. Overheating
will occur.

Kit Contents

Verify and remove contents from packaging before
beginning installation.

(1) Vent Cover

(1) Vent Back Plate

(10) Screws

Installation

1. Locate hand bends on the vent back plate as shown in
Figure 1. Use a screwdriver to bend them in the same
direction as the long and short bends.The number of
hand bends may vary by appliance size.

WARNING! Risk of Fire!

• Combustible materials MUST NOT overlap or be placed
behind a decorative front.

• DO NOT apply combustible materials beyond the
minimum clearances. Comply with all minimum

clearances to combustibles as specied. Overlapping

materials could ignite and will interfere with proper
operation of decorative fronts.

Preparation

CAUTION! Risk of Burns!

• The replace should be turned o and cooled before kit

is installed.

• Shut o gas supply.

Hearth & Home Technologies • PHTRIM-32LINEAR, PHTRIM-36LINEAR, PHTRIM-42LINEAR Instructions • 2616-971 Rev. D • 3/21

HAND BENDHAND BEND

Figure 1 Back Plate Hand Bends

1

2. Install the vent back plate with the bends oriented to­ward the wall and the longest bend on top. Attach the
vent back plate to the wall using eight screws. See
Figures 2, 4 and 5.

3. Attach the inside bends to the framing using two
screws. See Figure 5.

VENT BACK PLATE

SHORT BEND

4. Attach the vent cover to the vent back plate by lining
up the hooks of the vent cover plate to the slots on the
vent back plate. Slide cover to engage hooks. See
Figure 3.

SEE DETAIL A

VENT COVER

Figure 2 Orientation of Back Plate Bends

LONG BEND

DETAIL A

REAR VIEW

VENT COVER PLATE

Figure 3 Attach Vent Cover to Vent Back Plate - Rear View

2

Hearth & Home Technologies • PHTRIM-32LINEAR, PHTRIM-36LINEAR, PHTRIM-42LINEAR Instructions • 2616-971 Rev. D • 3/21

VENT BACK PLATE