HealthSmart 40-686-000 Instruction Manual

Instruction Manual

Model: 40-686-000

Instructions for Use

Please read these instructions carefully and keep them for future reference.

HealthSm art

TM

Cosmo Mist™ Ultrasonic Cool Mist Humidier

91-686-000 Cosmo Mist IM.indd 1 5/12/14 9:06 AM

KEY TO SYMBOLS

1) Mist Outlet Nozzle

2) Handle

3) Water Tank

4) Transducer

5) Reservoir

6) Base

7) Tank Cap

8) Power Indicator

9) Mist-adjustment/Power Knob

10) Transducer Cleaning Brush

2

1

7

8

9

10

6

5

3

4

91-686-000 Cosmo Mist IM.indd 2 5/12/14 9:06 AM

Important Safety Instructions

- For any issues with the equipment, refer to the troubleshooting section of this
manual, page 6. After removing all packaging materials, ensure that the humidier
has not been damaged during transport.

- Do not leave any packaging materials (plastic bags, cardboard boxes, etc.) within the
reach of children.

- Before connecting the equipment, ensure that the rated voltage (100-120 V, 50-60Hz)
corresponds to the main voltage supply of the electrical outlet.

- To avoid the risk of re, shock or injury, do not use additional power strip adapters
and/or extension cords.

- Do not touch the ultrasonic transducer with your hands or tools while the unit is
plugged in.

- Do not operate humidier when there is no water in the tank.

- Do not move, tilt or tip the humidier during use. Doing so may cause water leakage.

- Do not disassemble the base.

- Do not replace the power cord.

- If the supply cord is damaged, it must be replaced by the manufacturer in order to
avoid a hazard.

- Always disconnect the equipment from the power outlet when it is left unattended
or is not in use.

- The product is not a toy. Keep out of reach of children.

- Before performing any cleaning or maintenance, disconnect the equipment from the
power outlet.

- Only place the humidier on at, stable surfaces.

- Store and use equipment away from the heat sources like stoves

- Never touch the equipment with wet or damp hands.

- If the equipment is damaged and/or not working properly, turn the unit o

by disconnecting the plug from the power outlet.

- Do not touch the equipment if it falls into water.

91-686-000 Cosmo Mist IM.indd 3 5/12/14 9:06 AM

- Dispose of any worn accessories and/or equipment at an appropriate collection point
as required by state regulation(s).

- Do not direct the vapor ow toward furniture or electrical appliances.

How to Prepare and Use the Equipment

- Check that the equipment is completely clean, the power knob is in the OFF position

and the power cord is not connected to the power outlet.

- Gently remove the water tank from the base.

- Unscrew the cap and ll the water tank. (Puried or distilled water is best.)

- Screw the cap back on and place the water tank on the base securely.

- Place the mist outlet nozzle on top of the water tank, making sure it is correctly

positioned.

- Connect the equipment to a power outlet.

- Choose the desired mist volume by rotating the mist adjustment knob.

- The power indicator light illuminates green when the unit is ON, the vapor will begin

to release.

- To turn the unit OFF, turn the knob counter-clockwise until the unit clicks at which the

indicator light will also turn o.

- When the indicator light is Red, the humidier will not function because the water

level is too low.

- If the water tank is lifted during humidier use, operation will cease. When the tank is

returned securely to the base, operation will resume.

Note: When the tank is full, it is recommended that you carry the tank with both

hands.

Important Safety Instructions (continued)

91-686-000 Cosmo Mist IM.indd 4 5/12/14 9:06 AM

CAUTION!

- Before cleaning the equipment, always turn the humidier OFF and disconnect the
plug from the power outlet.

- Do not place the humidier directly under running water.

- Do not wet the power cable or air outlet.

- Do not scrape the ultrasonic transducer with metallic or sharp objects.

- Do not leave water in the tank when it is not in use.

- Dry all parts thoroughly before storage.

- Do not use abrasive products, alcohol, solvents or similar products that may cause
permanent damage to surfaces.

- Never submerge the equipment in water or any other liquid.

Cleaning and Maintenance

Base cleaning:

- Weekly cleaning is recommended.

- Wipe away any debris in the base and its components with a clean, soft cloth
or brush.

Transducer cleaning:

1. Apply a vinegar solution (50/50 mix of white vinegar and water) or detergent (small

amount) to the surface of the transducer and leave it on for two to ve minutes.

2. After 2-5 minutes, wash out solution.

3. Wipe away any debris with a clean, soft cloth or brush (included with unit).

Water tank cleaning:

1. Apply a 1/4 cup of vinegar or a small amount of dish detergent into the water tank.

2. Fill the tank half way with clean water.

3. Tighten the cap securely and shake the tank a few times, then empty contents.

5. Rell with clean water, shake again and empty contents.

91-686-000 Cosmo Mist IM.indd 5 5/12/14 9:06 AM