Congratulations on your purchase of a microprocessor controlled fully automatic pool cleaner. This
manual contains important information regarding the operation and maintenance of your cleaner. Please
retain it for reference. For Technical Assistance, call Hayward at 1300 POOLS1.
Hayward Robotic Cleaners should not be used to clean the pool for spring start-up. On those occasions,
where your pool is subjected to an abnormal debris load, maintenance steps should be taken to return
the pool to a clean condition.
HAYWARD only warranties the quality, performance and safety of its products when assembled with genuine
Hayward manufactured parts. Use of non-genuine Hayward manufactured parts will void all warranty.
Page 2 of 20
Rev. A
Basic safety precautions should always be followed, including the following: Failure to follow instructions can cause
severe injury and/or death.
This is the safety-alert symbol. When you see this symbol on your equipment or in this manual, look for one of the
following signal words and be alert to the potential for personal injury.
WARNING warns about hazards that could cause serious personal injury, death or major property damage
and if ignored presents a potential hazard.
CAUTION warns about hazards that will or can cause minor or moderate personal injury and/or property
damage and if ignored presents a potential hazard. It can also make consumers aware of actions that are unpredictable
and unsafe.
The NOTICE label indicates special instructions that are important but not related to hazards.
WARNING - Read and follow all instructions in this owner’s manual and on the equipment.
Failure to follow instructions can cause severe injury and/or death.
WARNING – This document should be given to the owner of the swimming pool and must be
kept by the owner in a safe place.
WARNING – This appliance can be used by children aged from 8 years and above and persons
with reduced physical, sensory or mental capabilities or lack of experience and knowledge if they
have been supervised/instructed and understand the hazards involved. Children shall not play with
the appliance. Cleaning and user maintenance shall not be done by children unless they are older
than 8 and supervised. Keep the appliance and cable out of reach of children under 8 years.
WARNING – To reduce risk of injury, do not permit children to use or climb on this product.
Closely supervise children at all times.
WARNING – HAYWARD only warranties the quality, performance and safety of its products when
assembled with genuine Hayward manufactured parts. Use of non-genuine Hayward manufactured
parts will void all warranty.
CAUTION – Regularly inspect the cleaner and cables; do not use if damaged or if any rough
edges are visible on the cleaner as this can cause damage to the pool.
WARNING – Never operate the cleaner when there are people in the pool.
WARNING – Before installing this product, read and follow all warning notices and instructions which
are included. Failure to follow safety warnings and instructions can result in severe injury, death, or property
damage.
CAUTION – Deterioration, discoloration or brittleness of any pool finish can be caused over time
separately by, or in combination with, age, incorrect pool water chemistry, improper installation, and other
factors. Customer hereby disclaims any and all claims, and releases Manufacturer from any and all claims
for damages to any pool plaster or vinyl liner in Customer’s pool by reason of the use and/or operation of the
Cleaner. Under no circumstances shall the Manufacturer be liable for any loss or damage, whether direct,
consequential or incidental, arising out of the use or inability to use the cleaner in Customer’s pool.
HAYWARD only warranties the quality, performance and safety of its products when assembled with genuine
Hayward manufactured parts. Use of non-genuine Hayward manufactured parts will void all warranty.
Page 3 of 20
Rev. A
DANGER
WARNING
CAUTION
WARNING: Electrical Hazard. Failure to follow
instructions can result in serious injury or death.
FOR USE WITH RESIDENTIAL SWIMMING POOLS
CONSUMER INFORMATION AND SAFETY
Risk of electrical shock or electrocution
The electrical supply to this product must be installed in accordance with all applicable
local codes and AS/NZS 3000. Improper installation will create an electrical hazard
which could result in death or serious injury to pool users or others due to electrical shock,
and may also cause damage to property.
Do not play with cleaner or cable or apply to body. Can trap or tear hair or body parts.
Cable can trip or entangle swimmers, which could result in drowning.
Before installing the cleaner, understand cleaner coverage. The cleaner was not designed
to automatically clean steps or to work under a solar cover. It was also not designed to do
initial cleanup for a new pool installation.
WARNING
Always stay out of the pool while cleaner is in operation or in the pool.
OPERATING THE CLEANER
A 30 mA differential protection device (RCD) must be installed to protect your electrical
WARNING
CAUTION
WARNING
WARNING
CAUTION
Keep the power supply control in shaded area.
The power supply control is equipped with an automatic shut off to prevent over heating if operated in direct sunlight.
outlet and to prevent any possible electric shock. Failure to do so could create an
electrical hazard which could result in death or serious injury to pool users or others due
to electrical shock and may also cause damage to property.
DO NOT switch the pool cleaner to “ON” if it is not immersed in the water. Operating the
cleaner out of the water may cause severe damage and will result in loss of warranty.
Always remember to turn off the power supply “OFF” and unplug it from the power outlet
before removing the cleaner from the pool.
It is mandatory to allow a safety distance between the power supply and the pool as
required by the current installation standard (3.5 m minimum).
Do not use an extension cord to connect to the power supply.
Power supply heat sink surface may be hot.
HAYWARD only warranties the quality, performance and safety of its products when assembled with genuine
Hayward manufactured parts. Use of non-genuine Hayward manufactured parts will void all warranty.
Page 4 of 20
Rev. A
IMPORTANT SAFETY INSTRUCTIONS
This robotic swimming pool cleaner has been manufactured with the highest degree of care and concern
for safety. We suggest the following safety precautions become part of your pool safety regulations:
SAVE THESE INSTRUCTIONS
1.WARNING - TO REDUCE THE RISK OF INJURY, DO NOT PERMIT CHILDREN TO USE THIS PRODUCT UNLESS
THEY ARE CLOSELY SUPERVISED AT ALL TIMES.
2. ALWAYS REMOVE THE CLEANER COMPLETELY FROM THE POOL PRIOR TO ENTERING THE POOL.
ALWAYS STAY OUT OF THE POOL WHILE CLEANER IS IN OPERATION.
3. ALWAYS PUT THE MACHINE INTO THE WATER BEFORE CONNECTING IT TO THE RCD PROTECTED ELECTRICAL
OUTLET.
4. BE CERTAIN THE MACHINE IS ONLY PLUGGED INTO A PROTECTED 230 Va.c OUTLET THAT IS PROTECTED
FROM SHORT-CIRCUITS. FIT A 30 mA DIFFERENTIAL PROTECTION DEVICE TO PROTECT PEOPLE FROM
ELECTRIC SHOCK CAUSED BY A POSSIBLE BREAK IN THE ELECTRICAL INSULATION.
5. DO NOT USE AN EXTENSION CORD. THIS COULD CREATE A SAFETY HAZARD AND/OR DAMAGE YOUR CLEANER.
6. DO NOT HANDLE MACHINE WHILE IT IS PLUGGED INTO THE ELECTRICAL OUTLET.
7. NEVER ALLOW PLUG TO ENTER THE POOL.
8. DO NOT OPERATE THE MACHINE OUT OF WATER. THIS WILL DAMAGE THE MOTOR SEAL AND VOID THE
WARRANTY.
9. DO NOT DRAG THE MACHINE OUT OF THE POOL AGAINST THE SIDE WALL. THIS COULD DAMAGE UNIT AND/OR
YOUR POOL WALL.
10. DO NOT BURY CORD. DO NOT OPERATE CLEANER WITH DAMAGED CORD. REPLACE DAMAGED CORDS
IMMEDIATELY.
11. IF THE SUPPLY CORD IS DAMAGED IT MUST BE REPLACED BY THE MANUFACTURER, SERVICE AGENT, OR
SIMILARLY QUALIFIED PERSONS IN ORDER TO AVOID A HAZARD.
12. To maximize the life of the cleaner, remove it from the pool when not in use and store in a shaded area.
13. Use the product at an altitude less than 2000 m.
While the cleaner has been made to operate as safely as possible, we suggest you exercise reasonable care in the handling
of the cleaner and inspect the electrical cord frequently for damage or wear, as with any other electrical appliance. After
use, remove the unit and rinse with fresh water and remove any twists that may be present in the cord. Store the cleaner
and power supply in a shaded area.
HAYWARD only warranties the quality, performance and safety of its products when assembled with genuine
Hayward manufactured parts. Use of non-genuine Hayward manufactured parts will void all warranty.
Page 5 of 20
Rev. A
WARNING - READ THESE IMPORTANT
STOP
Dear Hayward Robotic Cleaner Owner:
Thank you for choosing Hayward. In order to achieve optimal performance, please read and follow
these steps:
1. The power supply unit is suitable for outdoor use. It should always be kept out of direct sunlight, in a
shaded area. It should never be exposed to temperatures of above 40°C.
2. Cleaner
3. Before using your cleaner every time, ensure to remove larger items such as toys, large leaves and
sticks, or other debris from the pool that may diminish the cleaner’s performance.
4. For the first use, run the cleaner for the full cycle (3 hr walls and floor) to ensure a clean pool and
you a full understanding of the cleaner’s capabilities. Subsequent cleaning may only require the
Quick Clean cycle - 90 minutes (predominantly floor cleaning only).
5. In the Quick Clean Cycle the cleaner may periodically go to the wall but not necessarily climb to the
vertical position. This is a normal part of the programmed cycle.
OPERATING TIPS BEFORE USING YOUR UNIT!
6. Cleaner may stop in the middle of the pool and reverse during cleaning cycle. This is a normal part
of the programmed cycle.
7. DO NOT start cleaner out of the water. The unit will automatically shut off,
but it is best to unplug the power cord when unit completes cleaning.
8. Plug in only to a protected 230 Va.c
from short circuits . Fit a 30 mA(RCD) differential protection device to protect
people from electric shock caused by a possible break in the electrical
insulation.
9. Place the cleaner power supply so that it is at a minimum distance of 3.5 meters from the pool edge.
The length of the standard cleaner cable is 18.3 meters (60 feet).
10. Depending
pool, plus the depth at the deep end of the pool. To reduce cable tangling any excess cable should
be coiled and placed next to the power supply.
HAYWARD only warranties the quality, performance and safety of its products when assembled with genuine
Hayward manufactured parts. Use of non-genuine Hayward manufactured parts will void all warranty.
Page 6 of 20
(+/-6%) outlet that is close and protected
Rev. A
Loading...
+ 14 hidden pages
You need points to download manuals.
1 point = 1 manual.
You can buy points or you can get point for every manual you upload.