Haws 3511FR User Manual

INSTALLATION, OPERATION

&

MAINTENANCE INSTRUCTIONS

1455 Kleppe Lane Sparks, NV 89431-6467 [phone] Fax [phone]

E-mail: [e-mail]  website: www.hawsco.com

NOTE TO INSTALLER: Please leave this information with the Maintenance Department.

HAWS® warrants that all of its products are guaranteed against defective material or
poor workmanship for a period of one year from date of shipment. HAWS liability
under this warranty shall be discharged by furnishing without charge F.O.B. HAWS
Factory any goods, or part thereof, which shall appear to the Company upon
inspection to be of defective material or not of first class workmanship, provided that
claim is made in writing to company within a reasonable period after receipt of the
product. Where claims for defects are made, the defective part or parts shall be
delivered to the Company, prepaid, for inspection. HAWS will not be liable for the
cost of repairs, alterations or replacements, or for any expense connected therewith
made by the owner or his agents, except upon written authority from HAWS,
Sparks, Nevada. HAWS will not be liable for any damages caused by defective
materials or poor workmanship, except for replacements, as provided above. Buyer
agrees that Haws has made no other warranties either expressed or implied in
addition to those above stated, except that of title with respect to any of the
products or equipment sold hereunder and that HAWS shall not be liable for
general, special, or consequential damages claimed to arise under the contract of
sale. The drinking fountain manufactured by HAWS is warranted to function if
installation and maintenance instructions provided are adhered to. The units also
must be used for the purpose for which they were intended.

NO OTHER WARRANTIES EXPRESSED OR IMPLIED ARE AUTHORIZED, PROVIDED
OR GIVEN BY HAWS.

SHOULD YOU EXPERIENCE DIFFICULTY WITH THE INSTALLATION OF THIS
MODEL PLEASE CALL:

TECHNICAL SUPPORT: 1-800-766-5612

Model 3511FR

Drinking Fountain

LIMITED WARRANTY

No. 2077369 (8)

FOR CUSTOMER SERVICE: 1-888-640-4297

04/10 Model 3511FR Page 1 of 4

RECOMMENDED TOOLS: Hack saw, pipe joint sealant, screwdriver, level, 12"
adjustable wrench, 10" pipe wrench, 9/16”, 1/2”, 7/16” socket wrench or open end
wrench, 5/32” hex key wrench.

LOCATION OF UNIT: The Model 3511FR Drinking Fountain is a wheelchair
accessible drinking water facility. The height dimensions shown meet current ADA
requirements. When installing this unit, local, state or federal codes should be
adhered to. If height other than shown is required, then dimensions must be adjusted
accordingly.

SUPPLY LINE: The minimum recommended line size is 1/2“ IPS with 30-90 psi (2-6
ATM) flowing pressure. Where sediment or mineral content is a problem, an inlet filter
is recommended.

PLUMBING CONNECTIONS: Waste outlet is male 1-1/2” O.D. tailpiece.

MAINTENANCE: Refer to 6518.2FR Operation and Maintenance Sheet for more
information.

TROUBLESHOOTING

PROBLEM

REPAIR CHECKLIST

1. Insufficient bubbler flow. 1a. Check that inlet screwdriver stop
valve is wide open. (Customer
supplied)

b. Verify minimum 30 psi flowing

supply pressure.

c. Adjust valve to increase flow. See

6518.2FR Manual.

General Notes:

Before tightening nut and ferrule assembly, push tubing into fitting until it bottoms out to
ensure correct engagement with O-Ring.

For more information about Haws products, see our website: www.hawsco.com

© 2010 Haws® Corporation – All Rights Reserved
HAWS

®

and other trademarks used in these materials are the exclusive property of Haws Corporation.

04/10 Model 3511FR Page 2 of 4