Haws 3300FR User Manual

)

INSTALLATION, OPERATION

&

MAINTENANCE INSTRUCTIONS

1455 Kleppe Lane Sparks, NV 89431-6467 [phone] Fax [phone]

E-mail: [e-mail]  website: www.hawsco.com

NOTE TO INSTALLER: Please leave this information with the Maintenance Department.

HAWS® warrants that all of its products are guaranteed against defective material or
poor workmanship for a period of one year from date of shipment. HAWS liability
under this warranty shall be discharged by furnishing without charge F.O.B. HAWS
Factory any goods, or part thereof, which shall appear to the Company upon
inspection to be of defective material or not of first class workmanship, provided that
claim is made in writing to company within a reasonable period after receipt of the
product. Where claims for defects are made, the defective part or parts shall be
delivered to the Company, prepaid, for inspection. HAWS will not be liable for the
cost of repairs, alterations or replacements, or for any expense connected therewith
made by the owner or his agents, except upon written authority from HAWS, Sparks,
Nevada. HAWS will not be liable for any damages caused by defective materials or
poor workmanship, except for replacements, as provided above. Buyer agrees that
Haws has made no other warranties either expressed or implied in addition to those
above stated, except that of title with respect to any of the products or equipment
sold hereunder and that HAWS shall not be liable for general, special, or
consequential damages claimed to arise under the contract of sale. The drinking
fountain manufactured by HAWS is warranted to function if installation and
maintenance instructions provided are adhered to. The units also must be used for
the purpose for which they were intended.

NO OTHER WARRANTIES EXPRESSED OR IMPLIED ARE AUTHORIZED,
PROVIDED OR GIVEN BY HAWS.

SHOULD YOU EXPERIENCE DIFFICULTY WITH THE INSTALLATION OF THIS
MODEL PLEASE CALL:

TECHNICAL SUPPORT: 1-800-766-5612

FOR CUSTOMER SERVICE: 1-888-640-4297

Model 3300FR

Drinking Fountain

LIMITED WARRANTY

No. 2077342(11

04/10 Model 3300FR/330GFR Page 1 of 4

RECOMMENDED TOOLS: Hack saw, pipe joint sealant, screwdriver, level, 12" adjustable
wrench, 10" pipe wrench, 5/64” hex key wrench, 9/16”, 1/2", 7/16” socket wrench or open
end wrench.

LOCATION OF UNIT: The Model 3300FR/3300GFR Drinking Fountain is a wheelchair
accessible drinking water facility. The height dimensions shown, meet current ADA
requirements. When installing this unit, local, state or federal codes should be adhered to. If
height other than shown is required, then dimensions must be adjusted accordingly.

SUPPLY LINE: The minimum recommended line size is 1/2“IPS with 30-90 psi (2-6 ATM)
flowing pressure. Where sediment or mineral content is a problem, an inlet filter is
recommended.

PLUMBING CONNECTIONS: Waste outlet is female 1-1/2” Slip PVC.

MAINTENANCE: Periodically clean the strainer. Refer to 6518.2FR Valve Operation and

Maintenance Sheet for information.

TROUBLESHOOTING

PROBLEM

REPAIR CHECKLIST

1. Insufficient bubbler flow. 1a. Check that inlet screwdriver stop valve
is wide open. Turn counterclockwise.

b. Verify minimum 30psi flowing supply

pressure.

c. Clean inlet strainer.

d. Adjust valve to increase flow. See

6518.2FR Valve Manual.

General Notes:

Before tightening nut and ferrule assembly, push tubing into fitting until it bottoms out to
ensure correct engagement with O-Ring.

For more information about Haws products, see our website: www.hawsco.com

© 2010 Haws
HAWS

®

®

Corporation – All Rights Reserved

and other trademarks used in these materials are the exclusive property of Haws Corporation.

04/10 Model 3300FR/3300GFR Page 2 of 4