Hawaiian shaved ice S700 Instruction Manual

Electric Snow Cone Machine
Model #S700

Instruction Manual

Pg 2 - © 2013 Mary Mack’s, Inc.

SAVE THIS MANUAL FOR FUTURE USE

Registration

You may register this ice shaver through our website at

www.HawaiianShavedIce.com/register.html

Table of Contents

General Warnings 3
Usage Precautions 7
Warranty 9
Assembly/Parts Diagram for S700 (Fig. A) 11
Operation for S700 (Fig. B) 12
Assembly and Use 13
Cleaning 14
Shaved Ice Recipes 15

Mary Mack’s, Inc.

DBA Hawaiian Shaved Ice

321 Goldsboro Street

Newton Grove, NC 28366, USA

1-800-742-8334 – toll free

910-247-4152 – direct

770-234-6333 – fax

Pg 3 - © 2013 Mary Mack’s, Inc.

General Warnings and Safeguards

CAUTION

To prevent property damage and personal injury, it is important that you read
and follow all general warnings, safeguards and instructions.

Read the instructions provided in this booklet carefully because

they give important information with regards to the installation, use

and maintenance. Keep this manual for future reference.
This ice shaver is intended for household use only.
This ice shaver has an extremely sharp blade. You should use

extreme caution during assembly, operation, disassembly and

while cleaning the unit. If the blade becomes broken or loose,

do not use the appliance.

After unpacking the unit and before each use, make sure the

mechanical parts of the unit and all its attachments are intact. Look

for any foreign objects before operating the ice shaver. When in

doubt, do not use the appliance and refer to an authorized repair

center.
To prevent electrical shock to yourself or others, do not immerse

the cord, plugs, motor unit or any other electrical parts in water or

other liquids of any kind.
Use extreme caution to make sure you never place your fingers or

other items into the machine or the machine’s moving parts.

Pg 4 - © 2013 Mary Mack’s, Inc.

Do not operate the machine without ice.
Use this appliance for no more than 2 continuous minutes. Failure

to obey this may cause the ice shaver to overheat. Allow the

appliance motor to cool down before repeat usage.
All packing elements (plastic bags, polystyrene, etc.) should be

kept out of the reach of children because they are potentially

hazardous.
Before plugging the appliance into a power source, make sure the

voltage details marked on the appliance seal/plaque correspond to

those of your power supply. The seal/plaque is located on the

motor unit.
This appliance has a polarized plug (one blade is wider than the

other). As a safety feature, this plug will fit a polarized outlet only

one way. If the plug does not fit fully in the outlet, reverse the plug.

If it still does not fit, contact a qualified electrician. Do not attempt

to defeat this safety feature.
In the event the wall socket and the appliance plug are not

compatible, have the socket changed by a qualified professional

who must also ensure that the cross section of the socket wiring

corresponds to the power consumed by the appliance. Generally

speaking, adapters, multiple sockets, extension cords and/or drop

cords should not be used. However, if necessary, only use single or

multiple adapters and extension cables which comply with the

existing safety standards, making sure the current carrying capacity

limits marked on the single adapter and on the extension cables as

well as the maximum power limit marked on the multiple adapter

are not exceeded.
Do not use the machine around a hot surface or hot appliances.

Keep the appliance away from stovetops, broilers, ovens or any

other potentially hot appliance. Pay special attention to the

electrical cord to prevent it from touching a hot surface.

Pg 5 - © 2013 Mary Mack’s, Inc.

This appliance must be used only for the purposes it was designed

for, (i.e. for crushing/shaving ice in the home). Any other use must

be considered improper and therefore dangerous. The

manufacturer cannot be held responsible for any damages deriving

from improper, incorrect or unreasonable uses.
The use of any additional accessory attachments not

recommended by HawaiianShavedIce.com is not suggested.

Failure to obey this warning may cause fire, electric shock or injury

to yourself or others.
The use of any electric appliance requires the user to observe basic

rules.

In Particular:

Never touch the appliance with wet or damp hands.
Never use the appliance barefoot.
Never pull the electrical cable or the appliance itself to remove the

plug from the electrical socket.
Avoid all contact with any moving parts of the appliance.
Never leave the appliance exposed to the elements (rain, sunshine,

etc.).
Never let children or those unable to operate the appliance use it

unattended. Do not leave the unit unattended while plugged into a

power source.
Before any cleaning, maintenance, assembly or disassembly,

make sure that the ice shaver is disconnected from the main

power supply by unplugging it.

Should the appliance be out of order and/or operating inefficiently

switch it off and do not attempt to tamper with it. For any repairs,

approach an authorized service center only and request the use of

Pg 6 - © 2013 Mary Mack’s, Inc.

original spare parts. Failure to comply with the above might result in

compromised safety of the appliance.
Should you decide to stop using the appliance, it is advisable to

render it unusable by cutting the electrical cable after unplugging it

from the main power supply.
Furthermore, it is advisable to render all hazardous parts of the

appliance harmless, particularly for children, who might play with

the discarded appliance.
Installation must be carried out in compliance with the

manufacturer’s instructions. Incorrect installation can cause

damage to people, animals or objects for whom the manufacturer

may not be held responsible.
In order to avoid dangerous overheating it is advisable to unwind

the electrical cable completely and use the appliance as

recommended in the “Usage Precautions” paragraph.

Never leave the appliance plugged in when not needed. Unplug

from the power supply plug whenever the appliance is not in use.
Never obstruct the openings or slits for ventilation and heat

dissipation.
Should the electrical cable of this appliance become damaged,

have it replaced by a manufacturer authorized after-sales service

center only because special tools are required.
The manufacturer reserves the right to make any changes

considered necessary for industrial, commercial or design

improvements or to comply with particular standards. It is advisable

to pay particular attention to those warnings highlighted with the

symbol.