Page 1
INSTALLATION INSTRUCTIONS
MODEL WGI-C12
INTERIOR WINDOW GUARD KIT
2000-2005 CHEVY IMPALA
TOOLS REQUIRED:
Eye Safety Goggles
Power Drill
HARDWARE SUPPLIED:
QTY DESCRIPTION PART #
22 #10 x ½” Phillips Sheet Metal Screw GSM33194
1 Driver Side Window Guard WGI-C12-1
1 Passenger Side Window Guard WGI-C12-6
INSTALLATION:
1. First determine the correct window guard for each window. The bottom of each guard is
numbered, signifying its’ location.
2. Open door and hold the window guard up to the window door frame. NOTE: The angle at the
bottom of the guard framework faces towards the outside of the car. The guard framework fits
evenly around the window frame.
3. Mark a few holes at the top of the door frame using the pre-drilled holes on the guard framework
as a guide.
Note: Do not mark holes for the sides or bottom yet.
4. Remove window guard and drill holes as marked with a drill bit.
5. Attach window guard by using #10 x ½” sheet metal screws. Now locate and mark balance of
holes, drill and attach, starting at top and working your way down.
6. Follow the same steps for the other side of the vehicle.
1/8” Drill Bit
Phillips Screw Driver
WGI-C12-INST-10-04
Loading...