Havis-Shields P-MFK-9, P-REAR-1 W User Manual
INSTALLATION INSTRUCTIONS
P-REAR-1 W/P-MFK-9
REAR PARTITION W/FILLER PANEL MOUNTING KIT
1997-2008 CHEVROLET PASSENGER VANS
Always!
Read all instructions before installing any Havis-Shields Equipment Corp products.
Check for obstructions (Wire, brake lines, fuel tank, etc.) before drilling any holes!
Use hardware provided with install kit
TOOLS REQUIRED:
Power drill
Drill bit set
COMPONENTS:
QTY DESCRIPTION PART #
1 Partition P-REAR-1
1 Mounting Filler Kit P-MFK-9
P-MFK-9 COMPONENTS:
QTY DESCRIPTION
1 Passenger Side Filler Panel
1 Driver Side Filler Panel
HARDWARE:
DESCRIPTION PART #
QTY
5 ¼” x 1 ½” Hex Head Lag bolts GSM33062
2 ¼” x 3” Hex Head Lag bolts GSM33094
INSTALLATION:
• Place and position partition with spring clips facing towards rear of vehicle.
• Bottom frame of partition will be approximately 8 ½” from edge of door Frame.
• Partition will contour trim just inside rear doors of vehicle.
• Drill 3/16” pilot holes into floor of vehicle.
• Loosely bolt partition to vehicle using ¼” x 1 ½” Hex head lag bolts.
• Pre-drill top mounting holes with 3/16” bit. Attach to vehicle using ¼” x 3” Hex head
lag bolts.
• Tighten all loose hardware
• Install seat back to its original position
.
Standard socket set
Ratcheting wrench
P-REAR-1^MFK-9_INST_9-07
Approx. 8 ½”
¼” x 3” Hex Head Lag Bolts
¼” x 1 ½” Hex Head Lag Bolts
P-REAR-1^MFK-9_INST_9-07
Loading...