Havis-Shields P-MID-1 w, P-MFK-5 User Manual

INSTALL INSTRUCTIONS P-MID-1 w/P-MFK-5

MIDDLE PARTITION w/MOUNTING FILLER PANEL KIT

1997-2008 CHEVROLET/GMC FULL SIZE PASSENGER VANS

TOOLS REQUIRED:

Power drill
Drill bit set

HARDWARE:
QTY DESCRIPTION PART #

5 ¼” x 1 ½” Hex head Lag Bolt GSM33062
6 ¼” x 1” Hex head Lag Bolt GSM33060
20 ¼-20 x ¾” Carriage Bolt GSM32000
12 ¼-20 Serrated Nut GSM30023
8 ¼-20 Nylock Nut GSM30016
1 5/16-18 Nylock Nut GSM30017
1 5/16-18 x 2” Hex Head Bolt GSM33015
2 5/16 Flat Washer GSM31006
8 ¼” x 1” Fender Washer GSM31014

Passenger Side

Mounting Bracket

Ratcheting wrench
Standard & Metric socket set

Upper Center Steel

Filler Panel

Passenger Side Steel

Door Filler Panel

Main Partition

Frame

Driver Side Upper
Lexan Filler Panel

(2-Piece) Driver Side

“B” Pillar Mounting

Driver Side Lower

Steel Filler Panel

Bracket

SUB ASSEMBLY:

1. Remove “C” pillar trim panel. This is necessary for driver side mounting bracket.

2. Position upper center filler to partition and mark mounting holes.

3. Drill 5/16” holes on marks.

Always!

 Read all instructions before installing any Havis-Shields Equipment Corp products.
 Check for obstructions (Wire, brake lines, fuel tank, etc.) before drilling any holes!
 Use hardware provided with install kit

INSTALLATION:

1. ATTACH PARTITION TO FLOOR:

• Place partition carefully into vehicle behind the first
row bench.

• Move bottom of partition forward to the back of seat
base on first row bench.

Note: Driver side mounting leg on partition will be forward of seat belt
hold down on floor of van.

• Pre-drill the (3) driver side mounting leg holes with
3/16” drill bit. Be sure to check for obstructions.

• Attach partition to van floor at driver side mounting leg
using (3) ¼” x 1 ½” Hex head lag bolts.

• Proceed to partitions passenger side mounting leg. Be
sure to check that partition is square with the bench seat.

• Pre-drill the (2) passenger side mounting leg holes with
3/16” drill bit. Be sure to check for obstructions.

• Attach partition to van floor at passenger side mounting

leg using (2) ¼” x 1 ½” Hex head lag bolts. Partition is
now self-supporting.

2. ATTACH (2- PIECE) DRIVER SIDE
“B” PILLAR MOUNTING BRACKET:

• Hold 2-piece driver side mounting
bracket to partition and “C-pillar”
of van.

• Determine proper location to
mount 2-piece bracket to partition.

• Drill (2) 5/16” holes where
mounting bracket and partition
meet.

• Attach bracket to partition using
¼-20 x ¾” Carriage bolts and

¼” x 1 ½” Hex Head Lag Bolts

P-MID-1^MFK-5_INST_9-07