Page 1
LED Gooseneck Map Light
Installation Instructions
Warning: Please read all instructions and warnings prior to installation of the LED Gooseneck Map Light.
TOOLS REQUIRED:
Phillips Screw Driver
HARDWARE: (Supplied in Kit)
Qty. Description Qty. Description
2 #6 Machine Screw 2 #6 Split Lock Washer
2 #6 Thread Forming Screw 2 #6 Flat Washer
INSTALLATION:
1. Mounting:
• A drill template is provided on the back of this instruction sheet. Detach the
template, position it on the desired location for installation, and mark drill locations.
Caution: Before drilling holes, ensure that the mounting surfaces are clear and that the
screws will not damage the internal parts of the console or vehicle.
Caution: Ensure that the Gooseneck Map Light is installed in areas recommended by the
vehicle manufacturer—outside of the airbag zone.
• Drill the mounting holes.
• Remove the template prior to installing the fixture. Secure the base of the fixture in
position using the supplied machine screws and washers.
• The supplied super clip may be used to secure the gooseneck in position if desired.
Caution: Thread forming screws are supplied for alternate installations requiring the fixture to
be mounted from above. If the fixture needs to be disassembled for such installation, please
2. Wiring:
note that this will void your warranty.
• Connect the black lead to negative (ground.)
• Connect the red lead to hot (power.)
Note: It is recommended to install an in-line fuse holder and 1 Amp fuse on the red (hot) lead.
• Test the light for proper operation.
Wire Cutter/Stripper
Page 2
p
3. Operation:
• Power is supplied through a three-position switch. The center position is “off,” and
the up and down positions provide red or white light.
4. Troubleshooting:
• Use a voltmeter to ensure that the fixture is receiving adequate power. The light
requires nominally 12 VDC for correct operation. Correct any faults found.
• A bad ground connection can cause improper operation. Use a negative wire instead
of connecting power to the vehicle chassis to avoid any ground issues.
• The light will not be able to turn on if polarity is reversed.
+12 VDC
Power
1A Fuse
(Recommended)
Note:
Fuse, fuse holder, and connector are
not supplied by Havis-Shields.
Cli
Here
TEMPLATE:
∅0.50 (1/2” Drill)
Wireway
User-Supplied
Connector
(Optional)
HOT - RED
COMMON - BLACK
To Switch,
Circuit and
LEDs
Clip Here
∅0.16 (5/32” Drill)
Mounting Holes
1-23/3221/32
H:\Cons\Misc\LED-Map-Light-Inst-8-08.doc
Loading...