Havis-Shields GSM33062, KK-K9-F14-K, GSM32024, GSM32022 User Manual
INSTALLATION INSTRUCTIONS KK-K9-F14-K
K9 TRANSPORTATION SYSTEM
2003-2009 EXPEDITION
TOOLS REQUIRED:
Power Drill
Drill Bit Set
Standard & Metric Socket Sets
Phillips Screw Driver
Open End Wrench Set
HARDWARE:
QTY: DESCRIPTION: PART #:
28 ¼” x ½” Stainless carriage bolts GSM32022
8 ¼” x ¾” Stainless carriage bolts GSM32024
64 ¼” flanged serrated nuts GSM30023
6 ¼” x ¾” Hex head cap screw GSM33001
6 ¼” x 1 ½” Hex head lag screw GSM33062
36 #12 x ¾” Stainless sheet metal screws GSM34177
24 #10 x ¾” Stainless sheet metal screws GSM34170
12 #10 x ½” Stainless sheet metal screws GSM34169
10 #10 x ¾” Stainless machine screws GSM34098
6 #10 x ¾” Sheet metal screws GSM33195
1 Tube silver caulk PRM97343
1 46” x 45 ½” Rubber Floor mat KNM01029-SUV
10 #10 x ½” Flat head sheet metal screws GSM33150
Wire Cutters / Crimping tool
Ratcheting Wrench Extension
Torx Bit Set
4 ½” Hole Saw (Exhaust Fan Option)
Caulk Gun
Always!
¾ Read all instructions before installing any Havis-Shields Equipment Corp products.
¾ Check for obstructions (Wire, brake lines, fuel tank, etc.) before drilling any holes!
¾ Use hardware provided with install kit
For product support, visit the Install Instructions Section of our website at
http://havis.com/Installation/Installation.html, email technicalsupport@havis.com or call 1-800-
524-9900.
Assembled K9 Transportation System for
Rear of Unit
Rear Support Plate
(not shown)
2003-2009 Ford Expedition
Driver Side
Tunnel
Dome Light
Location for
11” Fan
(PRM97466)
Passenger Side
Tunnel
Mounting Legs &
Hold Down Plates
Front of Unit
2
KK-K9-F14-K_INST_11-08
SUBASSEMBLY:
Note: If doors have electric door switches, they must be reattached to original plug assembly. Switch
assembly must then be wired-tied down so it does not interfere with window or door latch operations.
View of Expedition door panel
Remove plastic trim piece. Metal
clips hold on trim
ove hex head screws holding
Rem e trim piece coverin
lower section of door panel
Remov g torx
screws under door panel armrest
and remove screws
Remove window/lock switch
assembly from door
Remove plastic door panel
Remove window switch and
reconnect. Wire tie switch in safe
location.
Recommended location to
relocate switch
3
Remove spe
aker from door panel.
Remove screws and unplug
KK-K9-F14-K_INST_11-08
Loading...