4
INSTALL INSTRUCTIONS C-VS-0309-F250
VEHICLE SPECIFIC CONSOLE
1999-2007 FORD F-250, 350, 450, 550
TOOLS REQUIRED:
Ratcheting wrench
Sockets Set
Cutting tool (if necessary)
HARDWARE:
QTY DESCRIPTION PART #
2 ¼” x 1 ¼” Hex head bolt GSM33003
2 ¼” Flat washer GSM31005
2 ¼” Serrated nut GSM30023
4 #8 x ¼” Phillips flat head sheet metal GSM33178
1 Torx Screw kit C-HK-1
Screwdriver set
T-20 torx bit
Always!
Read all instructions before installing any Havis-Shields Equipment Corp products.
Check for obstructions (Wire, brake lines, fuel tank, etc.) before drilling any holes!
Use hardware provided with install kit
For product support, visit the Install Instructions Section of our website at
http://havis.com/Installation/Installation.html, email technicalsupport@havis.com or call
1-800-524-9900.
located under the upper portion of
View of Ford F-Series dashboard
Remove (2) upper hex screws
the trim.
Remove upper portion of
dashboard as shown above
Remove (2) screws as shown
above
2
Remove enough to expose hex
screws holding lower portion of
dashboard
Remove plastic trim piece as
shown above
C-VS-0309-F250_INST_4-07
lower trim panel. This will reinstall
Remove (2) screws on lower side
sole to
dash using screws that held top of
Remove two hex screws on each
side of cup holder bracket
Remove lower trim panel
of lower trim panel. The insert
this screw attaches to will be
removed. See later instruction.
Remove plugs on optional brake
control switch. (If necessary)
Remove (2) hex screw as shown
above. Notice location.
Remove brake control switch from
into console. (Equipment bracket
sold separately)
Remove optional auxiliary
switches from trim panel
Current view of installation
3
Attach upper portion of con
lower trim panel
C-VS-0309-F250_INST_4-07
Complete installation of
Remove this screw clip to allow a
using ¼” x 1 ¼” hex bolt, washer
¼” bolt to fit into this hole
Attach lower portion of console
and serrated nut
C-VS-0309-F250 console
Complete installation of C-VS-0309-F250
console w/ accessories (Sold separately)
-Brake controller/Aux Switching equipment
bracket (C-EB30-F50-1P)
-Mic Clip Bracket (C-MCB w/ C-MC)
-Cup holder (C-CUP2-E-C with additional “L”
bracket # CM93086 )
4
C-VS-0309-F250_INST_4-07
Loading...