Havis-Shields C-VS-2400-CHGR-1, C-VS-2400-CHGR User Manual
INSTALL INSTRUCTIONS
C-VS-2400-CHGR & C-VS-2400-CHGR-1
2006 – 2007 DODGE CHARGER and MAGNUM
2008 DODGE CHARGER and MAGNUM
TOOLS REQUIRED:
Ratcheting wrench
Sockets - 7/16”, 10mm, 8mm
HARDWARE:
ITEM QTY DESCRIPTION PART#
1 1 Console housing assembly C-VS-2400-CHGR-H
2 1 Front support bracket CM001593
3 2 Side trim panels - 2006 – 2007 Charger CM001598-D and P
3 2 Side trim panels - 2008 Charger CM002164 and CM002165
4 1 Front floor bracket CM001595
5 1 Sensor guard CM001638
6 1 Rear floor panel CM001642
7 6 #10 x ½” machine screws GSM33118
8 2 #10 keps nuts GSM30028
9 4 #10 flat washers GSM31003
10 4 ¼” flat washer GSM31005
11 4 ¼” x ½” carriage bolt GSM31999
12 4 ¼” Nylock nut GSM30016
2 ¼” x ¾” self threading bolt GSM33060-1
2 ¼” x 1” fender washer GSM31014
2 6mm hex nut GSM30201
1 1-1/16” diameter plug GSM20017-1
1 Hardware Kit C-HK
1 Torx Hardware Kit C-HK-1
Screwdriver set
T-20 Torx bit
3
1
7, 9
5 - Not shown, approximate location
2
10, 11, 12 7, 9
4
6
b
Always!
Read all instructions before installing any Havis-Shields Equipment Corp products.
Check for obstructions (Wire, brake lines, fuel tank, etc.) before drilling any holes!
Use hardware provided with install kit
For product support, visit the Install Instructions Section of our website at
http://havis.com/Installation/Installation.html, email technicalsupport@havis.com or call 1-800-
524-9900.
2006-2007 Charger OEM Setup
Remove OEM track/plate &
plastic trim covering
Loosely attach, (driver side 1st),
front support bracket to OEM
racket located under radio controls.
Use #10 x ½” screw & keps nut
(Item 2, 7, 8, 9)
Note: Due to some slight differences on the OEM floor mount bracket, tabs with mounting hole may
need to be bent slightly to accommodate the console front support bracket. Bending these tabs can
easily be done using pliers.
OEM or 6mm
hardware
Attach passenger side, and tighten
hardware on both sides
(Item 2, 7, 8, 9)
Attach front floor bracket to front
support bracket and floor of vehicle
using #10 x ½” machine screws,
washers, and reuse OEM floor nuts or
supplied 6mm nuts and fender washers
(Item 2, 4, 7, 9)
2
Note. To avoid crushing harness
route cable over top of floor
bracket
C-VS-2400-CHGR_INST_12-07
Loading...