INSTALL INSTRUCTIONS C-VS-1800-ESC-1
TOOLS REQUIRED:
HARDWARE:
LINE DRAWING:
2008 FORD ESCAPE
VEHICLE SPECIFIC CONSOLE
• Phillips Screw driver
• T-20 Torx Bit
• Ratchet Wrench
• 7mm, 10mm sockets
QTY: DESCRIPTION: PART #:
18 8 x 1/4” Flat Head Phillips SMS GSM33187
2 3/4” Plugs GSM 20016
1 Torx screws C-HK-1
2 Bracket, Spacer, Front Gear Box Console CM002140
1 Bracket, Cons, Fuse Cover CM002142
1 Bracket, Cover, Shift Gear Box CM002150
1 Panel, DS, Front Console, Shift Gear Box CM002151
1 Panel, PS, Front Console, Shift Gear Box CM002152
Always!
• Read all instructions before installing any Havis-Shields Equipment Corp products.
• Check for obstructions (Wire, brake lines, fuel tank, etc.) before drilling any holes!
• Use hardware provided with install kit
• For product support: visit the Install Instructions Section of our website at
http://havis.com/Installation/Installation.html, email technicalsupport@havis.com
or call 1-800-524-9900.
C-VS-1800-ESC-1_INST_1-08
1
Carefully remove shift lever trim
bezel (unsnap)
Carefully remove top of OEM
console (unsnap)
Remove screw front lower sides
(7mm socket)
**SAVE HARDWARE**
Remove rear lower side screws
(10mm socket)
(7mm socket)
Unplug 12volt socket powerRemove front upper screws
**SAVE HARDWARE**
Remove OEM console New “Z” brackets installed
Attach new “Z” brackets (one each
side) with previously removed
OEM hardware. (7mm socket)
**DO NOT FULLY TIGHTEN
YET**
C-VS-1800-ESC-1_INST_1-08
2
Place new console housing
between seats
Attach to “Z” brackets with 1/4 x
3/4 Phillips head bolts
Tighten screws that attaches “Z”
bracket to OEM mount
Attach rear lower console to OEM
fl oor mount with OEM hardware
(10mm socket)
Make sure plate is evenly spaced to
allow trim bezel remounting
**DO NOT ATTACH YET**
Move shift lever to rear position
Passenger side fi ller panel
Place front console cover plate
around shift lever
Attach to console with #8 x 1/4”
fl at head sheet metal screws
C-VS-1800-ESC-1_INST_1-08
3
Attach fi ller panel to OEM mounts
with OEM hardware
(7mm socket)
Driver side fi ller panel
Attach same as passenger side
panel
Make sure top plate is evenly
spaced to allow trim bezel to snap
back in.
Insert 3/4” plugs in “Z” bracket
holes
Attach plate with #8 x 1/4” fl at
head sheet metal screws
Reattach trim bezel
Attach fuse panel cover
(#8 x 1/4” SMS)
1/4” nuts for side mount
accessories
(i.e. TCB-7, Mic-clip brackets, etc)
C-VS-1800-ESC-1_INST_1-08
4
Finish wiring and complete installation
C-VS-1800-ESC-1_INST_1-08
5
Loading...