Havis-Shields C-VS-1800-ECO User Manual

INSTALL INSTRUCTIONS C-VS-1800-ECO

2004-2008 FORD ECONOLINE VAN

TOOLS REQUIRED:

3/8” Standard Socket Set
3/8” Metric Socket Set
3/8” Ratcheting Wrench

HARDWARE & COMPONENTS:
QTY DESCRIPTION PART #

6 ¼-20 Nylock nut GSM30016
4 ¼” Flat washer GSM31005
2 ¼-20 x ¾” Carriage bolt GSM32000
4 ¼-20 x 1 ¼” Hex head bolt GSM33003
4 #10 x 1” Phillips sheet metal screw GSM33196
1 Torx Screw Hardware Kit C-HK-1

Always!

 Read all instructions before installing any Havis-Shields Equipment Corp products.
 Check for obstructions (Wire, brake lines, fuel tank, etc.) before drilling any holes!
 Use hardware provided with install kit

INSTALL C-VS-1800-ECO:

1. Remove O.E.M. engine cover accessory package (cup holder/storage pocket).

2. Place new console housing with mount brackets against engine cover and

floor. Mark engine cover and drill four (4) - 5/16” diameter holes. Mark
outline of floor bracket.

Powered drill w/ drill bit set
Open-end wrench set
Screw driver set

Also remove

washers from studs

C-VS-1800-ECO_INST_9-07

3. Remove mount brackets from console housing and attach to engine cover with
¼” x 1 ¼” hex head bolts, stop nuts and fender washers.

4. Mark and drill four 5/32” diameter holes and attach floor mount plate with
# 10 x 1” sheet metal screws. Also add two ¼” x ¾” carriage bolts facing up.

5. Mount and wire desired equipment into console.

C-VS-1800-ECO_INST_9-07