4
INSTALL INSTRUCTIONS C-VS-1200-EXPD-1
VEHICLE SPECIFIC CONSOLE
2007-2008 FORD EXPEDITION (w/ Console shifter)
TOOLS REQUIRED:
Ratcheting wrench
Sockets Set
Panel pulling tool
HARDWARE:
DESCRIPTION PART #
QTY
4 #10 x ½” Phillips machine screw GSM33118
4 #10 Keps nut GSM30028
Always!
Read all instructions before installing any Havis-Shields Equipment Corp products.
Check for obstructions (Wire, brake lines, fuel tank, etc.) before drilling any holes!
Use hardware provided with install kit
For product support, visit the Install Instructions Section of our website at
http://havis.com/Installation/Installation.html
Screwdriver set
T-20 torx bit
C-VS-1200-EXPD-1
Front
#10 x ½” Machine
screws and keps nuts
Rear
View of vehicle w/ full console
& console shifter
Remove hex head screw from
accessory pocket
Remove accessory pocket liner
as shown above
CAREFULLY remove trim
from around gear shifter
Remove trim from around the
cup holders
Remove trim panel from
console.
View of panel removed
2
Remove hex head screw from
accessory pocket/armrest
C-VS-1200-EXPD-1_INST_9-07
Remove (4) hex screws holding
armrest pad from hinge
Remove the rear OEM cup
holder
Remove hex head screws holding
side of accessory pocket
Pry up on accessory pocket trim
panel and remove
Remove hex head screws
holding rear of accessory pocket
Remove hex head screws holding
lower sides accessory pocket
Completely remove the container
of the accessory pocket
3
Parts removed from OEM
console
C-VS-1200-EXPD-1_INST_9-07
Replace the trim panel
previously removed earlier
Replace hex head screw on
accessory pocket
Replace trim panel around
factory cup holder
Position console so holes in side
of console align w/ holes in
factory console
Replace the trim panel around
gear shifter
Replace rear cup holders
Install #10 x ½” machine
screws and keps nuts as shown
above
View of console installed
4
View of specific application
including C-TCB-24, C-
ARM-2, C-3090-7, control
heads, etc..(Sold Seperatly)
C-VS-1200-EXPD-1_INST_9-07
Loading...