Havis-Shields C-TSM-CV-D User Manual
DRIVER and PASSENGER - TRUNK SIDE MOUNTS
h
TOOLS REQUIRED:
HARDWARE:
LINE DRAWING:
INSTALL INSTRUCTIONS
C-TSM-CV-D and C-TSM-CV-P
1996-2008 CROWN VICTORIA
• Drill with 1/8” and 3/16” drill bits
• Open End Wrench - 3/8”
• Phillips Screwdriver
QTY: DESCRIPTION: PART #:
3 10/32 X 1/2” Machine Screw GSM33118
3 10/32 Keps Nut GSM30028
3 #10 x 3/4” Sheet Metal Screw GSM33195
Passenger Side shown
# C-TSM-CV-P
Always!
• Read all instructions before installing any Havis-Shields Equipment Corp products.
• Check for obstructions (Wire, brake lines, fuel tank, etc.) before drilling any holes!
• Use hardware provided with install kit
• For product support: visit the Install Instructions Section of our website at
http://havis.com/Installation/Installation.html, email technicalsupport@havis.com or call 1-800-524-9900.
C-TSM-CV-P_INST_4-08
1
Installation:
Position frame assembly as shown.
Trunk liner does not have to be removed, but
you may want to cut it as needed to improve
access for routing wires.
Bottom frame mount attaches to the trunk
side fl oor. Drill three pilot holes with a 1/8”
(.125”) drill bit.
* Always check under fl oor before drilling *
Top frame mount attachs to the trunk
gasket mounting fl ange.
Drill three holes with a 3/16” (.187”) drill bit.
Attach top frame with three (3) - 10/32” x
1/2” machine screws and keps nuts.
Attach bottom frame with three (3) - # 10 x
3/4” sheet metal screws.
Driver side Trunk Side Mount complete.
Install electrical components as desired.
2
C-TSM-CV-P_INST_4-08
Loading...