Havis-Shields C-TM-CV User Manual
INSTALL INSTRUCTIONS C-TM-CV
1995-2007 FORD CROWN VICTORIA TRAK-MOUNT KIT
TOOLS REQUIRED:
Ratcheting Wrench
Metric Socket Set
HARDWARE:
QTY DESCRIPTION PART#
10 ¼” x ¾” Hex head bolt GSM33001
6 ¼” Serrated nut GSM30023
4 ¼” Flat washer GSM31005
4 ¼” Split lock washer GSM31026
SUB ASSEMBLY:
1. MOUNT TRAK TO HUMP BRACKETS.
• Determine location that Trak will land on transmission hump for the specific
application.
• With Trak in necessary location, measure Front and Rear Hump Bracket in relation to
Trak.
• Bolt trak to the front hump bracket, top plate using measurements taken in previous
step. Use (4) ¼-20 x ¾” Hex head bolts and serrated nuts.
Note: There are 2 different sides to the Trak Plate. It is recommended to mount Hump brackets to
side of Trak Plate that has ¼” hardware slots closer together, to better accept equipment, (consoles,
control heads, etc)
Standard Socket Set
Tape Measure
TRAK-MOUNT ASSEMBLY
Front Hump
Bracket (C-B33)
Trak Mount
¼” Hardware
Slots
Rear Hump
Brackets (C-B16)
• Attach trak to rear hump bracket using (2) ¼-20 x ¾” Hex head bolts and serrated
nuts.
Note: There is a driver and passenger side bracket to the Rear Hump Bracket. Top of
brackets will be parallel to the transmission hump.
INSTALLATION:
1. REMOVE SEATS:
• Remove rear seat base nuts (18mm).
• Slide seat to rear most position.
• Remove front seat base bolts (13mm).
• Seats do not have to come out of vehicle, they will just need to be tilted out of way to
place Trak-Mount assembly. Be careful of wire plugs if vehicle has power seats.
2. MOUNT ASSEMBLED TRAK-MOUNT:
• Attach the driver and passenger side front hump brackets to the inner front seat bolts.
• Place Trak-Mount assembly so rear hump bracket are between floor of vehicle and
seat base.
• Re-mount seats assembly and tighten all hardware.
• Mount equipment (consoles, control heads, etc).
Front Hump
Bracket
Rear Hump
Bracket
(Driver Side)
Trak
Rear Hump
Bracket
(Pass. Side)
2
C-TM-CV-INST-2-07
Loading...