3
INSTALL INSTRUCTIONS C-TCB-28
1997-2007 DODGE DAKOTA
TELESCOPING COMPUTER BASE
TOOLS REQUIRED:
Ratcheting wrench
3/8” Metric Socket Set
T-20 torx bit
3/8” Standard Socket Set
HARDWARE:
QTY DESCRIPTION PART #
4 ¼” x 1” Hex head lag bolt GSM33060
1 5/16” Flat Washer GSM31006
1 5/16” Nylock Nut GSM30017
1 “Z” Bracket Support CM002001
1 ¼” x ¾” Carriage Bolt GSM32000
1 ¼” Serrated Nut GSM30023
1 Pole Support Assembly CM93071-28W
1 Lateral Support Brace CM93146
1 Inner Telescoping Pole Assembly CM93072-3
Combination wrench set
Powered Drill
Drill Bit set
Always
Disconnect the vehicles’ battery. Removing seat bolts on some vehicles may give the
vehicles computer a false reading leading to warning lights on dash. This requires the
vehicles’ computer to be reset.
Read all instructions before installing any Havis-Shields Equipment Corp products.
Check for obstructions (Wire, brake lines, fuel tank, etc.) before drilling any holes!
Use hardware provided with install kit.
For product support, visit the Install Instructions Section of our website at
http://havis.com/Installation/Installation.html
1-800-524-9900.
!
, email technicalsupport@havis.com or call
CM93072-3
CM93146
CM93071-28W
Location of factory
seat bolts
Remove front bolts on passenger-
side seat and position base assembly
in front of seat mount brackets.
Tighten “Z” bracket to base
assembly.
Re-attach front bolts on passenger-
side seat through C-TCB base plate.
Pre-drill floor of vehicle with 3/16”
drill bit Use holes in the “Z” bracket
as a drill template
2
Install “Z” support bracket to base
assembly using ¼ x ¾” carriage bolt
and serrated nut.
Attach bracket to floor using ¼” x
1” hex head lag bolts
C-TCB-28-INST-6-07
Loosely attach lateral support brace
to TCB base using 5/16” flat washer
and 5/16” nylock nut
Tighten 5/16” nylock nut
Pre-drill floor of vehicle with 3/16”
drill bit. Use holes in the support
brace as a drill template
Insert inner telescoping pole
assembly and thread lock handle
into pole support base assembly.
Attach support brace to floor using
¼” x 1” hex head lag bolts
Final Installation
Install C-3090-x laptop platform (sold separately)
3
C-TCB-28-INST-6-07
Loading...