Page 1
INSTALL INSTRUCTIONS C-TCB-26
2002-2008 FORD EXPLORER
TOOLS REQUIRED:
Torx Bit Set (T-55)
3/16” Allen wrench
3/8” Standard Socket Set
3/8” Metric Socket Set
HARDWARE:
QTY DESCRIPTION PART #
1 Pole support assembly CM93071-26W
1 Telescoping pole assembly CM93072-1
1 Side support brace CM93135
1 5/16” Nylock nut GSM30017
2 5/16” Flat washer GSM31006
1 5/16-18 x 1” Hex head bolt GSM33012
2 ¼” x ¾” Hex head lag bolt GSM33060-1
Always!
Read all instructions before installing any Havis-Shields Equipment Corp products.
Check for obstructions (Wire, brake lines, fuel tank, etc.) before drilling any holes!
Use hardware provided with install kit
3/8” Ratcheting Wrench
Powered drill
3/16” & 5/16” Drill bits
Open-end wrench set
Telescoping
pole assembly
Location of factory
seat bolts
Side support
brace
Pole support
assembly
C-TCB-26_INST_9-07
Page 2
SUB ASSEMBLY:
1. Confirm receipt of all hardware and components.
2. Remove front inner and outer passenger seat bolts on vehicle.
INSTALLATION:
1. MOUNT TELESCOPING COMPUTER BASE:
• Position pole support assembly on top of passenger seat base mount and align holes in
pole support assembly with holes in seat base.
• Loosely attached factory seat bolts that were removed during subassembly.
• Loosely mount side support brace to threaded rod located on pole support assembly
using a 5/16-18 Nylock nut
• Mount side support brace to vehicle using ¼” x ¾” Hex head lag bolts. A 3/16” pilot
hole is required.
Note: When mounting side support brace to floor of vehicle, be sure to check for obstructions prior to
drilling or lag bolting to floor.
• Tighten down factory passenger seat bolts and 5/16-18-nylock nut holding side
support brace to pole support assembly.
• Mount optional C-3090, computer-mounting platform, to telescoping pole assembly
using hardware and instructions provided with C-3090.
C-TCB-26_INST_9-07
Loading...