Havis-Shields C-TCB-19 User Manual

INSTALL INSTRUCTIONS C-TCB-19
UNIVERSAL SIDE MOUNT
TOOLS REQUIRED:
3/16” Allen wrench
3/8” Standard Socket Set 3/8” Ratcheting Wrench
HARDWARE: QTY DESCRIPTION PART #
1 Pole support assembly CM93071-19 1 Telescoping pole assembly CM93072-1 8 ¼-20 Nylock nut GSM30016 16 ¼” Flat washer GSM31005 8 ¼-20 x ¾” Hex head bolt GSM33001
Powered drill w/ drill bit set Open-end wrench set
Always!
Read all instructions before installing any Havis-Shields Equipment Corp products. Check for obstructions (Wire, brake lines, fuel tank, etc.) before drilling any holes! Use hardware provided with install kit
SUB ASSEMBLY:
1. Confirm receipt of all hardware and components.
2. Determine location to mount TCB.
INSTALLATION:
1. MOUNT SUPPORT BRACKETS:
With location determined, mark mounting holes using lower support bracket as template.
Drill ¼” holes on these marks.
Attach lower support bracket to desired surface using ¼-20
x ¾” hex head bolts, washers and nylock nuts.
Following same procedure for lower support bracket mark and drill holes for upper support bracket.
Mount optional C-3090, computer-mounting platform, to telescoping pole assembly using hardware and instructions provided with C-3090.
Telescoping pole
assembly
Upper Support Bracket
Lower Support Bracket
C-TCB-19-INST-8-05