Havis-Shields C-TCB-12 User Manual

INSTALL INSTRUCTIONS C-TCB-12

TELESCOPING COMPUTER BASE

1992-1996 FORD BRONCO

TOOLS REQUIRED:

3/16” Allen wrench
3/8” Standard socket set
3/8” Torx set

HARDWARE & COMPONENTS:
QTY DESCRIPTION PART #

1 Pole support assembly CM93071-12
1 Telescoping pole assembly CM93072-3
1 Side support brace CM93162
1 5/16-18 Nylock nut GSM30017
1 5/16” Flat washer GSM31006
2 ¼ x 1Hex head lag bolt GSM33060

3/8” Ratcheting wrench
Open-end wrench set
Powered drill w/ 3/8” drill bit

Telescoping pole

assembly

Pole support

assembly

Side support brace

¼” x ¾”Hex

head lag bolts

5/16-18 Nylock

nut

C-TCB-12-INST-7-05

SUB ASSEMBLY:

1. Confirm receipt of all hardware and components.

2. Loosen or remove front inner and outer passenger seat bolts on vehicle.

Always

!

 Read all instructions before installing any Havis-Shields Equipment Corp products.
 Check for obstructions (Wire, brake lines, fuel tank, etc.) before drilling any holes!
 Use hardware provided with install kit

INSTALLATION:

1. MOUNT C-TCB-12 INTO VEHICLE:

• Position Pole support assembly on top of passenger seat base front mount.

• Loosely attach inner and outer factory seat bolts.

• Attach Side support brace to pole support assembly using a 5/16-18 Nylock nut and

flat washer.

•

Attach side support brace to floor of vehicle using ¼” x 1” Hex head lag bolts. A
3/16” pilot hole is required.

Note: Be sure to take caution when drilling through vehicle to avoid hitting brake or gas lines, wires,
or any other obstructions.

•

Tighten factory seat bolts and 5/16” nylock nut.

•

Re-attach Telescoping pole assembly to pole support assembly.

•

Mount optional C-3090, computer-mounting platform, to telescoping pole assembly
using hardware and instructions provided with C-3090.

C-TCB-12-INST-7-05