Havis-Shields C-MCB-CV User Manual
INSTALL INSTRUCTIONS C-MCB-CV
DUAL IN-DASH MICROPHONE CLIP BRACKET
1996-2007 FORD CROWN VICTORIA
TOOLS REQUIRED:
Ratcheting wrench
Sockets - 7/16”, #10, #8
Screwdriver set
T-20 torx bit
Always
Read all instructions before installing any Havis-Shields Equipment Corp products.
Disconnect the vehicle battery. Removing seat bolts on some vehicles may give the vehicles
computer a false reading, causing a warning light on the instrument cluster. This requires the
vehicles’ computer to be reset with a vehicle diagnostics tool.
Check for obstructions (Wire, brake lines, fuel tank, etc.) before drilling any holes!
Use only hardware provided with install kit.
For product support, visit the Install Instructions Section of our website at
http://havis.com/Installation/Installation.html, email technicalsupport@havis.com or call 1-
800-524-9900 and ask for technical support.
!
Police Package Crown Vic Dash. Carefully remove trim panel
Remove hex head trim screws
shown above
C-MCB-CV-INST-6-07
Slide bracket between trim around
radio and the trim panel
previously removed
Replace screws previously
removed
Re-attach trim panel
Install microphone clip brackets
using #8 x ½” machine screws
and hex nuts
Final assembly
2
C-MCB-CV-INST-6-07
Loading...