Page 1
CD-PULS500
CD-PULS750
PULSAR HANDHELD SPOTLIGHT
INTRODUCTION
Congratulations. You have purchased the most efficient and versatile 12 volt lighting
system available. Please take a few minutes to read these instructions, as it contains
information to provide optimum performance from your Modular Searchlight.
Page 2
IMPORTANT! READ BEFORE USE
DO NOT look directly into the light, or shine directly into eyes. Eye damage may result.
DO NOT use light in explosive atmospheres. It is NOT explosion-proof. Fire may result.
DO NOT touch hot bulbs. Allow bulb to cool before replacing.
DO NOT place face down on any surface during operation. Fire may result.
DO NOT attempt to service light wiring or switches. Return to factory for service.
OPERATING YOUR LIGHT
1. Remove your Model CD-PULS500 or CD-PULS750 Handheld light from its
packaging.
2. Read the safety warning noted above in these instructions.
3. Plug the “cigarette lighter” style plug at the end of the coiled cord into any “cigarette
lighter” style outlet providing 12 Volts DC.
4. Push the “Momentary” switch to light the CD-PULS500 spotlight.
Push the “Momentary ON / OFF /ON” button to light the CD-PULS750 spotlight.
5. The switch provides selection of HI power spot or LOW power flood beams. Center
position is off.
6. Enjoy the light.
FEATURES
Your Searchlight is designed to be operated directly from a 12 volt cigarette lighter outlet
or in conjunction with an accessory CD-BP-12 rechargeable battery pack and includes a
9 ft. coil cord.
Scene Lighting Technology
Candlepower Rating 500,000 Spot 750,000 Spot
Amp Draw (12 Volts) 7.8 Amps 7.8 Amps Spot
Bulb 100 Watt H-1 Base 100 Watt Spot H-2 Base
Standard Switch Momentary Switch Momentary On / Off / On Switch
Leader In
CD-PULS500
Part Number
Part Number
CD-PULS750
5,000 Flood
4.3 Amps Flood
55 Watt Flood H-2 Base
- 2 -
CD-PULSAR-INST-9-06
Page 3
BENEFITS
• Protective glow ring (bezel) helps prevent lens breakage and provides an
indication that the light is on if placed face down.
• Bulb mount design allows replacing bulb quickly without tools.
• Quartz halogen bulbs provide brilliant white light and last up to 100 hours.
• Standard 9 foot coil cord minimizes voltage drop for maximum power.
OPTIONS & ACCESSORIES
Part Number Description
CD-DMB-1 Dash mounting clip for mounting the Pulsar & Genesis handheld
light unit
CD-RR-46 Hypalon Rubber Ring For 6" reflector diameter
CD-RR-56 Hypalon Rubber Ring For 7” reflector diameter
CD-H1100W Replacement bulb for CD-PULS500
CD-H2100W Spot replacement bulbs for CD-PULS750
CD-H255W12 Flood replacement bulbs for CD-PULS750
BULB REPLACEMENT
CD-PULS500
1. Remove the rear cap by twisting counter
clockwise.
2. Remove wire lead from bulb, removed
spring clip and pull bulb out of reflector
3. Take new bulb out of box. Handle bulb only
by rear terminal. DO NOT HANDLE
GLASS PORTION OF BULB.
4. Insert new bulb through rear reflector mount
so that bulb flange is seated flush against the
back of the reflector housing. (Bulb will
only fit flush one way).
5. Fasten bulb retainer spring clip in hole and
notch.
6. Re-install wire lead onto back of bulb.
7. Replace rear cap by twisting clockwise.
CD-PULS750
1. Remove the rear cap by twisting counter
clockwise.
2. Grasp bulb mount assembly and withdraw
from head. Separate sections
3. Remove bulb to be replaced. Use cloth. Insert
new bulb and check for proper alignment.
4. Connect bulb mount sections and slide into
head. Note alignment slots.
5. Check alignment in reflector. Two dowel pins
must protrude through reflector for proper
alignment.
6. Replace cap onto head, twist clockwise to
lock.
- 3 -
CD-PULSAR-INST-9-06
Page 4
TROUBLESHOOTING Q & A
Q: If my searchlight does not operate, what are likely problems?
A: Check for proper connection in cigarette lighter outlet. Rotate plug to help clean
and make a connection.
Q: Is damage likely if the light is operated for extended periods?
A: Your Pulsar searchlight is constructed of the finest thermo-plastic available.
Although it may become warm to the touch, it is designed to withstand continuous
operation.
Q: Is my searchlight waterproof?
A: Your Pulsar searchlight is NOT designed to be submerged, although its design is
highly weather resistant and may be used with confidence in inclement weather.
Q: Are replacement bulbs, accessories and parts available?
A: Yes. You may order items from your dealer or call Havis-Shields Equipment
Corporation Customer Service toll free at 1-800-524-9900.
WARRANTY
Havis-Shields Equipment Corp. will warrant all furnished equipment against parts failure or malfunction
due to design, construction, assembly errors, and/or defective workmanship for a period of two years from
date of purchase excluding bulbs. Proof of purchase is required for lights manufactured more than 24
months prior to the date of the warranty claim. Customer must request factory Return Authorization
Form and receive authorization number prior to submitting goods.
Havis-Shields Equipment Corporation
75 Jacksonville Rd · Warminster, PA 18974
Ph: 800-524-9900 or 215-957-0720
Fax: 215-957-0729
CustomerService@Havis.Com
www.Havis.com
- 4 -
CD-PULSAR-INST-9-06
Loading...