Havis-Shields CM001516, C-B1, C-HK, C-B27, C-VS-1300-TBZ User Manual
4
INSTALL INSTRUCTIONS C-VS-1300-TBZ
VEHICLE SPECIFIC CONSOLE
2006-2008 CHEVROLET TRAILBLAZER
TOOLS REQUIRED:
Phillips screwdriver
T-15 Torx driver
T-20 Torx driver
7/16 wrench
Ratchet wrench
7/16” socket
HARDWARE:
QTY DESCRIPTION PART #
1 Trailblazer vehicle specific console C-VS-1300-TBZ-H
1 Bail bracket C-B1
1 Rear hump bracket set C-B27
1 Duct block off plate CM001516
2 Side “L” brackets CM93594
1 Console hardware kit C-HK
1 Torx screw kit C-HK-1
1 #10x1/2 PPHSMS (Block off plate screw) GSM33194
15mm socket
Jig Saw or plastic cutting tool
Eye goggles
Always
Read all instructions before installing any Havis-Shields Equipment Corp products.
Disconnect the vehicle battery. Removing seat bolts on some vehicles may give the vehicles
computer a false reading, causing a warning light on the instrument cluster. This requires the
vehicles’ computer to be reset with a vehicle diagnostics tool.
Check for obstructions (Wire, brake lines, fuel tank, etc.) before drilling any holes!
Use only hardware provided with install kit.
For product support, visit the Install Instructions Section of our website at
http://havis.com/Installation/Installation.html
1-800-524-9900 and ask for technical support.
, email technicalsupport@havis.com or call
!
d
Remove six phillips screws that hol
inner storage pocket. Remove
storage pocket and arm rest
assembly.
Remove shift lever “T” knob.
(T15 Torx)
Remove main console screws.
Unplug wires for rear controls.
Measure approximately 3 ½” back
from shift lever boot.
Mark Measurement with tape.
Position shift lever in drive or
further back. Remove entire
console assembly.
Note: In order to remove console,
you must reach up inside the shifter
boot and disconnect the traction
Remove front trim to aid in running
additional wiring.
control plug.
2
C-VS-1300-TBZ_INST_9-07
Loading...