haupa AH-12, AO-6 Instruction Manual

... convincing solutions

Electro-hydraulic crimping tool

„AH-12“

Art. 216503

INSTRUCTION MANUALHydraulic crimping tools

Video 216503

1. Technical data

Area of application: For the creation of an electrical connection by means of compression
Scope of delivery: 1 crimping tool, 1 charger, 1 battery, 1 carry strap, in a plastic case,

without dies.
Pressing force: 120 kN
Oil type: ISO class viscosity 15
Feed rate: 2 speeds: Closing (fast) feed to bring the pressing dies to the conductor

and working feed for compression. Switching between the two speeds is

carried out automatically.
Safety: The tool is fitted with a safety value that has been set at the factory.
Structure: The working head can be rotated by 180° to make it easier to adapt to

the operation to be carried out. The hydraulic crimping tool does not

protect the operator when working on cables that carry power.
Guarantee: 2 year guarantee if used for the purpose it is intended.

2. Area of work

2.1. Sensortechnology

• Pressing force in kN: 120 kN

• Working pressure in bar: 700

• Opening/ Hub: 20 mm

• Pressing width: width

• Motorstop

• H-head „Deep Indent Pressing“: Cu/Al Tube Cable lugs and connectors

• Crimping range cable lugs: Cu 10-400 / DIN Cu 10-300 / DIN Al 16-240

• Crimping range connectors: Cu 10-400 / DIN Cu 10-300 / DIN Al 16-240

• Pressing time, battery-operated in seconds: 6-12

• Battery charging time in minutes: 120

• Battery type: Li-Ion, 18 V, 4 Ah

• Dual-piston pump

• Weight in kg: 7

• Weight of set in kg: 12

With the different colours of the sensor LED, it shows whether the pressing has
been completed successfully or which errors have occurred:

Light is green: Pressing completed as standard, motor stopped

Light is orange: Battery voltage not sufficient

Light is red: Pressing interrupted before completed

The device also has 2 white LED designed to illuminate the working area.

Germany: HAUPA GmbH & Co. KG, Königstraße 165-169, D - 42853 Remscheid.

Phone: [phone], Fax: [phone], [e-mail] • Errors and technical changes reserved.

english

... convincing solutions

3. Operating instructions

CAUTION! TOOLS MAY NEVER BE USED WITHOUT FIRST INSERTING THE PRESSING DIES.
Ensure that the pressing dies fit precisely to the appropriate area and are seated perfectly in
the holders.
OTHERWISE THIS MAY CAUSE SERIOUS DAMAGES OR BREAKAGES AND THE GUARANTEE
WILL BE VOIDED.

Preparation:

Before starting up the tool, read the operating instructions first.
All current-carrying elements in the area you are working in should be disconnected.
Otherwise the protective procedures for working in the vicinity of
components under current must be implemented. (DIN EN 50110)
Do not use the tool if you are tired or under the influence of medication, drugs or alcohol.
Take into account the valid accident prevention and safety regulations and use the tool exclu­sively for the purpose for which it is intended.
Only electro-technically trained persons over 16 years of age may process connecting materi­als using the tool.
The operating instructions must always be carried with the tool.
The instructions must have been read and understood by the user.
The operator must ensure that this is the case.

Operating:

• Select the appropriate pressing dies for the connection to be pressed.

• Insert the pressing dies in the tool head. All of the pressing dies that can be used in

Pushbutton

to advance

Die holder

Pushbutton for
return movement