Hatteras Hammocks Double Cushioned Swings none User Manual
If you have any questions regarding our products, call our
toll-free consumer customer service line: 800.643.3522
Visit our web page: www.hatham.com
Double Cushioned Swing
Congratulations on your purchase of the Hatteras Hammocks® Double Cushioned Swing.
We believe that you will find it a product of unsurpassed quality and durability.
Hatteras Hammocks designed the Double Cushioned Swing to be
both beautiful and functional using only the highest quality materials. It may be hung from a sturdy limb or beam (strong enough to
support at least 450 lbs.) or from one of the swing stands that we
offer. We hope you will enjoy years of pleasure and relaxation from
this swing.
The box contains:
1 - Double Swing Cushion Hardware:
1 - Oak Top Stick (4 sided) 2 - 3" x 3/8” Carriage Bolts
1 - Oak Bottom Stick (5 sided) 2 - 2 1/2" x 3/8” Carriage Bolts
2 - Curved Oak Arms 2 - 1 1/4" x 3/8” Carriage Bolts
2 - Chain and Ring Assemblies 10 - 3/8” Nuts
2 - Tree Hooks 14 - 3/8” Washers
You also will need:
A 9/16" wrench
An electric drill (not necessary if you plan to hang your swing on a
swing stand).
Assembly Instructions:
NOTE: If you plan to hang your Double Cushioned Swing on
a swing stand, make sure your stand is assembled according
to its instructions before you begin assembling your swing.
1. Insert the top stick (4 sided) through the sleeve at the top
of the swing cushion back (the sleeve attached to the
smallest section of cushion). Next, slide the bottom (5-sided)
stick into the sleeve at the
bottom front of the cushion (the sleeve attached to the
largest
section of cushion). Make
sure the narrowest flat side of the
Fig. 1
Swing Canopy Instructions now. Follow the instructions for
the assembly of the canopy through step #6. Then, return
to this instruction sheet, skipping steps #2-#4, and picking
up the swing assembly instructions at step #5.
2. To connect the swing arms, position each arm with two
holes at the top. (See Fig. 1) Insert (from the front to back)
a 2 1/2" carriage bolt through the arm’s top hole then
bottom stick is facing up into the curve
of the arm. If this is inserted in the wrong
direction, completely remove the stick
and insert correctly. Incorrect insertion will
cause chafing and possibly tearing of the
fabric.
NOTE - If you plan to attach a canopy to
your swing at the time of swing assembly,
please refer to your Double Cushioned
Fig. 2
through the second hole from the end of the top
stick. (See Fig. 2) HAND TIGHTEN ONLY using a washer
and a nut.
3. To connect the other end
of the same arm to the
bottom stick, insert a 3"
carriage bolt, first
through the
bottom hole of the
curved arm. (See
Fig. 3) then
through the
second hole from
the end of the
bottom stick.
4. Repeat steps 2
and 3 for
the other arm.
Fig. 3
5005 p.1
1.OD
Double Cushioned Swing
If you have any questions regarding our products, call our
toll-free consumer customer service line:
800.643.3522
Visit our web page: www.hatham.com
Fig. 4
5. To attach the chain assemblies, work on one side at
a time. On one of the chain-and-ring
assemblies, find the shorter section of
and-ring assemblies, find the shorter section of chain
with an eye bolt. Place a washer on this eye bolt, and
insert the eye bolt through the outside hole on one
end of the top stick. Tighten using a washer, a nut,
and a 9/16" wrench. (See Fig. 4)
6. On the same chain assembly used in step 5, find the
longer section of chain with an eye bolt. Place a washer
on this eye bolt and insert the eye bolt through the
outside hole (drilled through the narrow side) of the
bottom stick. Tighten using a washer, a nut, and a 9/16"
wrench.
7. Repeat steps 5 and 6 for the other side.
9. Finish assembly by squaring up the swing and
making sure that all bolts are tightened with a
wrench.
10. Adjust the height of the swing with the chains for
maximum comfort. When you sit in the swing, your
feet should touch the ground with your knees slightly
bent.
Care and Maintenance:
The Hatteras Hammocks Double Cushioned Swing is
crafted using the highest quality outdoor fabric
available. It is designed to be weatherable and to resist
fading. However, in order to keep your swing in the best
condition, it may be prudent to bring it indoors during
extreme conditions.
The nature of the acrylic or acrylic blend fabric makes it
easy to clean. Simply wash it briskly with a soapy solution
of liquid dishwashing detergent and warm water. Rinse
your cushion thoroughly with clean water to remove
the soap, and let it air dry. For stubborn stains or suntan
oil, use brush tip or Kleenol 1 spot remover. Follow the
directions on the container, sponge the area thoroughly
with clean water, and air dry.
8. Hang your swing before you tighten all the carriage
bolts.
If you plan to hang your swing from a tree limb or beam:
a. Select a location that is 6 1/2 - 8 1/2 feet off the
ground and will support at least 450 lbs. When
installing the tree hooks that accompany your swing,
first drill a 1/8"-3/16" pilot hole. (Pilot hole should be as
small as possible in order to ensure safe assembly and
use of swing.) Insert the screw hook to the point that
the eye of the screw is in contact with the surface of
the hole. NOTE: Do not over-twist the hook assembly.
This may cause damage to the metal and weaken the
support.
b. If installing the swing into any surface other than
wood, consult a professional for the proper method
and the additional supplies needed for a safe
installation.
c. Hook one chain assembly on each of the tree
hooks.
DO NOT ALLOW CHILDREN TO USE THE
HAMMOCK WITHOUT DIRECT ADULT
SUPERVISION. DO NOT HAVE INFANTS IN
THE SWING.
WARRANTY INFORMATION:
Products of The HammockSource are guaranteed to be free of
defects in workmanship and materials for up to one year after
the purchase date. Prolonged exposure to weather conditions
including snow, rain, and humidity are not covered under the
warranty nor is damage caused by normal wear, mildew, or
improper care including storage, maintenance, and installation.
If an item is found to be defective within one year of its
purchase, it will be replaced without charge upon the return of
the unit accompanied by a sales receipt. If you choose to
return an item, you must contact our customer service
department at 800.334.1078 to obtain a Return Authorization
Number that will allow us to track your unit once it arrives at our
warehouse; thereby creating a faster response to your concern.
The HammockSource - Post Office Box 1602,
Greenville, North Carolina 27835
Consumer Customer Service: 800.643.3522
5005 p.2
1.OD
Loading...