Hathaway NG1043D Owner's Manual

WINNER’S CHOICE

SISAL DART BOARD

OWNER’S MANUAL

Please Do Not Hesitate to

Contact Our Consumer Hotline

with Any Questions That May

Arise During Assembly or

Use of This Product!

at

800-759-0977

Ver. 0516

NG1043D

#9

DARTS
(6 PCS)

Part Part Number

1 Dartboard NGP2075
2 Mounting Bracket NGP5613

3-

5 Hardware NGP2076
7 Rubber Bumper NGP5612
9 Darts NGP2077

2

ASSEMBLY INSTRUCTIONS

Setup/Mounting lnstructions

Choose a location to hang the dartbord where there is about 10 feet of open space in front of the board.The“toe-line” should be

7’ 9-1/4” from the face of the dartboard.

Dartboard Mounting lnstructions

1. Attach Mounting Bracket to the cabinet. Bracket should be positioned inside of the wood cabinet with open end of groove facing up.
Align holes in bracket to the holes inside the middle of the cabinet. Slide the two bolts through the back of the cabinet bracket holes
so that the bolt tips point towards the inside of the cabinet. Tighten the nuts and washer around the bolts inside the cabinet to
secure the mounting bracket.

2. Using the small nails provided, attach the three rubber bumpers to the back of the dartboard. There will be guide holes to assist you
with the location of the bumpers.

3. Drive the 1” wood screw into the middle of the dartboard so that 1/4” of the screw is visible. Note: this screw should not protrude
further out from the dartboard than the rubber bumpers. Lay cabinet flat and position the middle dartboard screw onto the mounting
bracket. Readjust the screw if necessary for tight flush fit.

Cabinet Mounting Instructions

Locate a solid wood beam and place a mark on the wall 76” high from the floor.Measure 16” across from your first mark and place
your second mark. These will be the marks used to mount the top of wood cabinet to the wall. Line up the top holes inside the cabinet
with the marks you’ve made and secure with 2 screws. After the cabinet is secure, insert two screws into the bottem two holes inside
the cabinet and tighten the cabinet to the wall. If you are unable to locate two wood beams to mount your cabinet, you will need to
purchase drywall anchors from your local hardware store.
After the cabinet is installed, the bull’s-eye height should be 5’ 8” from the floor.

Mounting Bracket Back of Dartboard

Inside of Cabinet

Dartboard Set-up Diagram

Wall Stud

Bumper

Screw

Bumper

Dartboard

Top Screws 76”

Bottom Screws

Floor

5’ 8” from Floor
to Center of
Bulls-Eye

7’ 9-1/4”

5

3