Hatco LFST-41 Installation Manual

FLAV-R-SAVOR
®
Large Capacity Holding Cabinet
LFST-41 Series
Installation and Operating Manual
I&W #07.05.214.00
Do not operate this equipment unless you have read and understood the contents of this manual! Failure to follow the instructions contained in this manual may result in serious injury or death. This manual contains important safety information concerning the maintenance, use, and operation of this product. If you’re unable to understand the contents of this manual, please bring it to the attention of your supervisor. Keep this manual in a safe location for future reference.
No opere este equipo al menos que haya leído y comprendido el contenido de este manual! Cualquier falla en el seguimiento de las instrucciones contenidas en este manual puede resultar en un serio lesión o muerte. Este manual contiene importante información sobre seguridad concerniente al mantenimiento, uso y operación de este producto. Si usted no puede entender el contenido de este manual por favor pregunte a su supervisor. Almacenar este manual en una localización segura para la referencia futura.
© 2009 Hatco Corporation
CONTENTS
NOTICE
CAUTION
WAR NING
Important Owner Information ...............................................i
Introduction............................................................................i
Important Safety Information...............................................1
Model Description.................................................................2
Model Designation................................................................2
Specifications........................................................................2
Plug Configurations .........................................................2
Electrical Rating Chart .....................................................2
Dimensions......................................................................3
Installation.............................................................................4
General............................................................................4
Assembly .........................................................................4
Operation...............................................................................5
General............................................................................5
Changing the Setpoint Temperature................................5
Locking/Unlocking the Digital Temperature Controller .....5
IMPORTANT OWNER INFORMATION
Record the model number, serial number (specification label located on the side of the unit), voltage, and purchase date of the unit in the spaces below. Please have this information available when calling Hatco for service assistance.
Model No. ____________________________________
Serial No. ____________________________________
Voltage ______________________________________
Date of Purchase ______________________________
Maintenance ..........................................................................6
General............................................................................6
Cleaning ..........................................................................6
Replacing Display Light Bulbs .........................................6
Removing the Air Supply Tubes ......................................6
Removing/Installing the Sliding Doors .............................7
Troubleshooting Guide ........................................................8
Accessories...........................................................................9
Hatco Limited Warranty........................................................9
Authorized Parts Distributors............................Back Cover
Business 8:00 a.m. to 5:00 p.m. Hours: Central Standard Time
(Summer Hours: June to September – 8:00 a.m. to 5:00 p.m. C.S.T. Monday through Thursday 8:00 a.m. to 2:30 p.m. C.S.T. Friday)
Telephone: (800) 558-0607; (414) 671-6350
Fax: (800) 690-2966 (Parts and Service)
(414) 671-3976 (International)
INTRODUCTION
The Hatco Flav-R-Savor®Large Capacity Holding Cabinet is designed to hold prepared foods for prolonged periods of time while maintaining that “just-made” quality. It provides the best environment for wrapped foods and sandwiches by regulating the air temperature.
Flav-R-Savor air flow pattern is designed to maintain consistent cabinet temperature. The left and right side heat sources create a “blanket” effect around the food. The air flow rate enables the cabinet to rapidly recover temperature after opening and closing the doors.
Front and rear access doors and adjustable shelves make the Hatco Flav-R-Savor Large Capacity Holding Cabinet perfect for any food service application.
The Flav-R-Savor Large Capacity Holding Cabinet is a product of extensive research and field testing. The materials used were selected for maximum durability, attractive appearance and optimum performance. Every unit is inspected and tested thoroughly prior to shipment.
24 Hour 7 Day Parts and Service Assistance available in the United States and Canada by calling (800) 558-0607.
Additional information can be found by visiting our web site at www.hatcocorp.com.
in
t
a
r
e
p
o
d
n
ty, a
e
f
, sa
n
tio
lla
sta
in
s
e
d
i
v
o
r
p
l
a
u
n
ma
is
Th
t
s
in
b
a
C
fe
sa
tall
s
in
Safety inf
e fol
th
WAR
oi
av
CA
oi
av
NOTICE is used to address practices not related to personal injury.
n
o
ti
c
u
r
t. H
e
in
tr
s
ty in
on or ope
ati
ormat
lowin
NING i
ded, coul
ION i
UT
ded, coul
s
a u
g
e Fla
r th
fo tco c
sig
ndi
ndi
mme
o
c
e
r
n
tio
ion that appears in this
nal word pa
cates a hazardou
re
d
cates a ha
re
d
s rati
sul
sul
a
a
e
p
p on of th
n de
t i
n minor or
t i
-
v
n
r
Sa
-
R
s a
d
g
in
e
ne
ath or
zardo
vo ll in
th
in
nit
u
:
ls
g
r
a
r L
lla
a
t
s
n
is ma
.
manual is iden
s situa
ous
seri
us situ
moderat
e C
tio
u
t
ation
pa
a
o
,
n
e
l b
a
on whi
i
ury.
inj
njury.
i
e
it
c
r
e
p
a
e
r
which
ld
o
H
y
, a
g
in
t
a
r
io
r
p
d
tified by
ch, if no
, if no
in
n
g g d
to
t
t
i
Form No. LFST41M-0109
IMPORTANT SAFETY INFORMATION
NOTICE
CAUTION
WARNING
Read the following important safety information before using this equipment to avoid serious injury or death
and to avoid damage to equipment or property.
ELECTRIC SHOCK HAZARD:
• Plug unit into a properly grounded electrical receptacle of the correct voltage, size, and plug configuration. If the plug and receptacle do not match, contact a qualified electrician to determine and install the proper voltage and size electrical receptacle.
• Turn the power switch OFF, unplug the power cord, and allow the unit to cool before performing any maintenance or cleaning.
• DO NOT submerge or saturate with water. Unit is not waterproof. Do not operate if unit has been submerged or saturated with water.
• Unit is not weatherproof. Locate the unit indoors where the ambient air temperature is a minimum of 70°F (21°C).
• Do not steam clean or use excessive water on the unit.
• Do not pull unit by power cord.
• Discontinue use if power cord is frayed or worn.
• Do not attempt to repair or replace a damaged power cord. The cord must be replaced by Hatco, an Authorized Hatco Service Agent, or a person with similar qualifications.
• This unit must be serviced by qualified personnel only. Service by unqualified personnel may lead to electric shock or burn.
• Use only Genuine Hatco Replacement Parts when service is required. Failure to use Genuine Hatco Replacement Parts will void all warranties and may subject operators of the equipment to hazardous electrical voltage, resulting in electrical shock or burn. Genuine Hatco Replacement Parts are specified to operate safely in the environments in which they are used. Some aftermarket or generic replacement parts do not have the characteristics that will allow them to operate safely in Hatco equipment.
BURN HAZARD: Some exterior surfaces on the unit will get hot. Use caution when touching these areas.
The National Sanitation Foundation (NSF) requires that units over 36″ (914 mm) in width or weighing more than 80 lbs. (36 kg) either be sealed to or raised above the installation surface.
Locate the unit at the proper counter height in an area that is convenient for use. The location should be level to prevent the unit or its contents from falling accidentally and strong enough to support the weight of the unit and contents.
Do not move or relocate the unit for cleaning. The unit is bulky and heavy.
Use non-abrasive cleaners only. Abrasive cleaners could scratch the finish of the unit, marring its appearance and making it susceptible to soil accumulation.
FIRE HAZARD: Locate the unit a minimum of 1″ (25 mm) from combustible walls and materials. If safe distances are not maintained, discoloration or combustion could occur.
Use only light bulbs that meet or exceed (National Sanitation Foundation (NSF) standards and are specifically designed for food holding areas. Breakage of light bulbs not specially coated could result in personal injury and/or food contamination.
Make sure food product has been heated to the proper food-safe temperature before placing in the unit. Failure to heat food product properly may result in serious health risks. This unit is for holding pre-heated food product only.
This unit has no “user-serviceable” parts. If service is required on this unit, contact an Authorized Hatco Service Agent or contact the Hatco Service Department at 800-558­0607 or 414-671-6350; fax 800-690-2966; or International fax 414-671-3976.
Form No. LFST41M-0109
1
MODEL DESCRIPTION
Sign Holder
Air
Supply
Tube
Sliding Doors
Adjustable Shelf
WARNING
NEMA L14-20P
L F S T - 41
Large Capacity
Width (inches)
Tall
Flav-R-Savor
Flav-R-Savor in black or other optional Designer colors. Painted surfaces are powder-coated painted steel and aluminum. The cabinet contains four tempered glass doors for easy access and visibility from front or back. The two front doors are self-closing sliding doors. The two rear doors are self-closing, French-style doors. The cabinet sides are tempered glass for good visibility and heat retention. The floor of the cabinet is made of Decorative Stone and is available in four standard colors. The interior top is made of easy-to-clean stainless steel. Dual heaters and fans along with four corner-mounted air supply tubes create a dry heat system that is suitable for all boxed or wrapped food products.
The three adjustable shelves have product stops and can be positioned horizontally or inclined toward the service area for excellent product visibility. The interior of the cabinet has incandescent lighting to heighten product awareness. A removable sign holder on the top of the unit provides a space for customer-supplied signage.
Accessories available include Halogen light bulbs in place of the incandescent light bulbs. Refer to the ACCESSORIES section for details.
®
Large Capacity Holding Cabinets come standard
MODEL DESIGNATION
Figure 1. LFST-41 Cabinet with Sign Holder (Customer Side)
Figure 2. Model Designation
SPECIFICATIONS
Plug Configuration
Units are supplied from the factory with an electrical cord and plug installed. Plugs are supplied according to the applications.
ELECTRIC SHOCK HAZARD: Plug unit into a properly grounded electrical receptacle of the correct voltage, size, and plug configuration. If the plug and receptacle do not match, contact a qualified electrician to determine and install the proper voltage and size electrical receptacle.
NOTE: Receptacle not supplied by Hatco.
Electrical Rating Chart
Model Voltage Watts Amps Plug Configuration Shipping Weight
LFST-41 120/208 2150 14.6 NEMA L14-20P 200 lbs. (91 kg)
120/240 2150 14.6 NEMA L14-20P 200 lbs. (91 kg)
Figure 3. Plug Configuration
2
Form No. LFST41M-0109
Loading...
+ 8 hidden pages