© Copyright 2012 Hatch Industries Limited
RACK DISPENSER WITH TUBES
-STAINLESS STEEL -IN COUNTER
-CANTILEVER DESIGN -SINGLE OR DOUBLE
-SELF LEVELING, FIELD ADJUSTABLE -ENCLOSED
-HEATED
Model Series: TRCH-IC-2T*
APPLICATION:
-Cafeterias
-Serving lines
-Serving stations
CAPACITY:
-Approximately 5 to 6 doz. saucers per tube
-Racks: 5 to 6 racks per stack
DISPENSES:
-Saucers
-Cups/soup cups in racks
SPECIFICATIONS:
-Stainless steel; Type 304
-“Heliarc” and spot welded construction
-Cantilever dispensing system
-Dispensing system in a steel upright uni-frame
enclosure
-Dispensers are equipped with non-rusting springs
that are heat treated for strength & durability
-Built in enclosed chassis installation with frame
-Channel reinforced base
-Double paneled insulated sides for heat retention
-2 removable, field adjustable drop-in tube dispensers (DTO-DI)
-“On/Off” switch and pilot light are mounted on the top flange
-Approved power supply cord with 3 prong end cap
ELECTRICS:
-120V, 60Hz, 1 Phase, 1000 Watts
-NEMA 5-15 end cap
OPTIONAL FEATURES [1]:
-NP - Stainless steel nameplate
-Remove (*) from model code for non-NSF models
See model series DTO-DI for more information on Tube Dispensers.
© Copyright 2012 Hatch Industries Limited
RACK DISPENSER WITH TUBES
-STAINLESS STEEL -IN COUNTER
-CANTILEVER DESIGN -SINGLE OR DOUBLE
-SELF LEVELING, FIELD ADJUSTABLE -ENCLOSED
-HEATED
Model #: TRCH-IC-2T*
Model #: TRCH-IC-2-2T*
Maximum saucer diameter is 6.5” (165mm).
Height from mounting surface to bottom of unit is 27.5” (698.5mm).
Refer to factory for counter cut-out locations and dimensions.