Hatch HCV-S-R User Manual

Standard belt

direction

TRAY MAKE UP CONVEYOR

-STAINLESS STEEL -BELT DISTRIBUTION

-MODULAR DESIGN -LOWER RACEWAY

-VARIABLE SPEED -STATIONARY

Model Series: HCV-S-R-

APPLICATION:

-Tray Makeup Preparation

SPECIFICATIONS:

-Stainless steel; Type 304

-“Heliarc” and spot welded construction

-Stainless steel tubular upright legs fastened to
heavy gauge, die formed body

-Modular design allows unit to be shipped
completely assembled or dis-assembled with
final assembly performed at job site as required

-Easy cleaning, endless, laminated belt with take-up adjustment

-Belt scraper with crumb catcher for continuous
cleaning during operation

-Variable belt speed control located at “finish” end of conveyor

-“Start” and “stop” controls at both “start” and “finish” end of conveyor

-Automatic tray stop with variable delay setting at “finish” end of conveyor

-Lower electrical raceway has removable cover and
provision for plug-in receptacles to allow conveyor to be
used as the power base for the entire tray makeup system

-6 receptacles provided as standard (more available as optional extras)

-Each receptacle is on its own circuit breaker and is wired for maximum 30 amp load

-Receptacles will be installed to match other equipment in tray makeup system

-Conveyor controls wired to their own circuit breaker

-100 amp main breaker panel with main disconnect is standard
with a 200 amp panel and larger drive/breaker housing
available when receptacles exceed the 100 amp rating

-18” end cap on both ends is standard (12” and/or 24” available)

-Drive/breaker panel housing with locking, removable access panels on 3 sides

-Vibration dampening adjustable mounting feet allow for
variable working heights and makeup of uneven floor surfaces

OPTIONAL FEATURES [1]: HOW TO SELECT CONVEYOR MODEL:

-CB - Corner bumpers 1) Choose belt length (in one foot increments)

-LB - Linear bumpers running along both sides 2) Choose end cap length
This will determine overall conveyor length

ELECTRICAL OPTIONS: e.g. 10 foot belt = 12” start end cap & 18” finish end cap

-Consult factory for exact power supply requirements = 12.5 foot overall
Model is determined by belt length only.
Please note: This model is available with casters to a max 10 foot belt = HCV-S-10-R
60 amp electrical capacity only