REFRIGERATED COOLER DISPENSER
-STAINLESS STEEL -IN COUNTER
-DOUBLE SPRING BANK MECHANISM -SELF-CONTAINED
-SELF LEVELING, FIELD ADJUSTABLE -SINGLE OR DOUBLE
Model Series: CO-IC-C-
APPLICATION:
-Cafeterias
-Serving lines and stations
CAPACITY:
-Racks: up to 5 racks per stack
-Baskets: up to 5 baskets per stack
DISPENSES:
-Racks or baskets of milk or beverage cartons,
prepared salad bowls, packaged novelties or
misc. chinaware
SPECIFICATIONS:
-Stainless steel; Type 304
-“Heliarc” and spot welded construction
-Built-in chassis installation with compressor and controls
where unit is required to operate as a self-contained unit
-Cabinet is complete with evaporator tubing, compressor,
controls and bottom drain
-Fan cooled hermetically sealed condensing unit
-Evaporator tubing is refrigerant grade solid wall copper
and is located all around the interior liner
-Sealed interior liner is isolated from cabinet exterior by a
plastic breaker strip for condensation control
-Interior liner is separated from cabinet exterior on all sides
by a layer of rigid non-sag insulation
-Die formed uni-frame assembly with upright support channels
-Removable double spring bank dispensing mechanism with roller
bearings fit into guide runners for smooth operation
-Dispensers are equipped with non-rusting springs
that are heat treated for strength & durability
-Adjustable temperature range from 0°F (-18°C) to +55°F (+13°C)
-Approved power supply cord with 3 prong end cap
OPTIONAL FEATURES [1]: ELECTRICAL DATA:
-NP - Stainless steel nameplate -120V, 60Hz, 1 Phase, 8 Amps
-CC - Clear lexan, removable, hinged cover -NEMA 5-15 End Cap
-Unit height of 26” (660mm) or 30” (762mm) -208V or 240V available upon request
REFRIGERATED COOLER DISPENSER
-STAINLESS STEEL -IN COUNTER
-DOUBLE SPRING BANK MECHANISM -SELF-CONTAINED
-SELF LEVELING, FIELD ADJUSTABLE -SINGLE OR DOUBLE
Model #: CO-IC-C-
Model #: CO-IC-C-2
Custom sizes are available but will need to be coordinated with custom baskets.
Overall height of all listed units is 28” (711mm).
Contact factory for counter cut-out locations and dimensions.
Double units require 2 covers – one for each rack size.