STEAM
REGULATOR
WIRING INSTRUCTIO
NS
1.
--,
How to Install SR-3
• Remove the old lowboy from the steam line
· • Attach a 1/
bow or T shape) to the steam line as
Figure
• Connect the steam hose from SR-3 to the
iron. and plug in the cord.
• Turn the power switch on.
2. Wiring Instructions
Plug with 4 Wire From
tric Iron
Disassemble the 4-pole male plug, and ar-
I•
I
range each component part along the electri- I
I
I
cal line as shown in Figure 2. I
The inner part
in rear as shown
screws), four pins
bered from
the male plug body has a hole to insert the
wire. (Figure
• Adjust the length
them so that when completed, there is no
left-over wire outside
Connect 4-wire cord as shown
2"
threaded fitting (straight el-
L.
of
40016 4-Pole Male
AH-2100 Steam Elec-
of
the male plug has 4 screws I
in
Figure 3 (wire clamping
in
front. Each
1 through 4, and each angle
2)
of
each wire and re-strip
of
the 4-pole housing.
is
in
in
the
num-
Figure
of
3.
I
Figure 2
are located here.
l
Wire Clamping screws
I
1
~
igur
.
~
-
-
~--
-·
.
·1
l
'
'" ---
'Each angle has a hole to insert each
~-------
l
-~
.L
__
_____________
----
wire
~
.....!
White
line
to Pin #1
Black line to
Red line to Pin #3
Green line to Pin #4 (Ground Wire)
' •
Re-assemble each component part and
tighten the housing with the screw.
• Plug the male plug into SR-3, and secure the
male plug with the lock
that
is
Pin
with SR-3.
#2
of
the female plug
Figure 1
r-------
ITo Steam Line
I
~•
i
_.:1
i
l
~----~----------·------·J
.--------------'-··
Each pin has a number (Pin
Pin-~ 4 ha~-~-gr~und
----------
sign.
#1-Pin
-----·-·1
#3). 1
..
..
~J
Loading...