![](/html/c6/c6ff/c6ff172cfdd5f79a95cca0ca53131807797f451e3d374560811ee48069e58119/bg1.png)
AGES 4
+
85432/85182 Asst.
Revenge of the Sith
Insert Force lightning
into arms.
FORCE
LIGHTNING
EMPEROR PALPATINE
®
Batteries included. Replace with 3 x 1.5V “A76” or LR44 size alkaline batteries.
™
Phillips/crosshead screwdriver (not included) required to replace batteries.
BUTTON
™
Press button – head turns to
change from Palpatine to Darth
Sidious and lightning glows.
Change arms for
lightsaber attack.
HAND
Some poses may require additional support. Product and colors may vary.
© 2005 Lucasfilm Ltd. & ® or TM where indicated. All rights reserved.
Used under authorization.
®* and/or ™* & © 2005 Hasbro.
® denotes Reg. U.S. Pat. & TM Office.
*
For more toy information visit: www.starwars.hasbro.com
*
LIGHTSABER
P/N 6445770000
![](/html/c6/c6ff/c6ff172cfdd5f79a95cca0ca53131807797f451e3d374560811ee48069e58119/bg2.png)
To Replace Batteries:
Using a Phillips/crosshead screwdriver (not included), loosen screw
in battery compartment cover. Remove cover. Remove and discard
batteries. Insert 3 x 1.5V “A76” or LR44 size alkaline batteries. Replace
door, and tighten screw with screwdriver. See diagrams for polarity.
BATTERY
CAUTION:
1) As with all small batteries, the batteries used with this
toy should be kept away from small children who still put
things in their mouths. If they are swallowed, promptly see a
doctor and have the doctor phone (202) 625-3333 collect.
2) Make sure the batteries are inserted correctly and follow
the toy and battery manufacturer’s instructions.
3) Do not mix old and new batteries, alkaline, standard
(carbon-zinc) or rechargeable (nickel-cadmium) batteries.
IMPORTANT: BATTERY INFORMATION
Please retain this information for future reference.
Batteries should be replaced by an adult.
COVER
CAUTION:
1. Always follow the instructions carefully. Use only batteries specified and be sure to insert item correctly by
matching the + and – polarity markings.
2. Do not mix old batteries and new batteries or standard (carbon-zinc) with alkaline batteries.
3. Remove exhausted or dead batteries from the product.
4. Remove batteries if product is not to be played with for a long time.
5. Do not short-circuit the supply terminals.
6. Should this product cause, or be affected by, local electrical interference, move it away from other electrical
equipment. Reset (switching off and back on again or removing and re-inserting batteries) if necessary.
7. RECHARGEABLE BATTERIES: Do not mix these with any other types of batteries. Always remove from
the product before recharging. Recharge batteries under adult supervision. DO NOT RECHARGE OTHER
TYPES OF BATTERIES.
8. As with all small items, these batteries should be kept away from children. If swallowed, seek medical
attention immediately.
This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions: (1)
This device may not cause harmful interference, and (2) this device must accept any interference received,
including any interference that may cause undesired operation. Changes or modifications to this unit not
expressly approved by the party responsible for compliance could void the user’s authority to operate the
equipment. This equipment has been tested and found to comply with the limits for a Class B digital device,
pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection against
harmful interference in a residential installation. This equipment generates, uses and can radiate radio
frequency energy, and, if not installed and used in accordance with the instructions, may cause harmful
interference to radio communications. However, there is no guarantee that interference will not occur in a
particular installation. If this equipment does cause harmful interference to radio or television reception,
which can be determined by turning the equipment off and on, the user is encouraged to try to correct
the interference by one or more of the following measures: - Reorient or relocate the receiving antenna. Increase the separation between the equipment and receiver. - Consult the dealer or an experienced radio/TV
technician for help.
FCC Statement: