Be sure to insert the batteries correctly and
always follow the toy and battery manufacturers'
instructions;
2.
Do not mix old batteries and new batteries or
alkaline, standard (carbon-zinc) or rechargeable
(nickel-cadmium) batteries;
3.
Always remove weak or dead batteries from the
product.
IMPORTANT: BATTERY INFORMATION
Please retain this information for future reference.
Batteries should be replaced by an adult.
A
1.
2.
3.
4.
5.
6.
7.
CAUTION:
Always follow the instructions carefully. Use only batteries specified
and be sure to insert item correctly by matching the
markings.
Do not mix old and new batteries or standard (carbon-zinc) with
alkaline batteries.
Remove exhausted or dead batteries from the product.
Remove batteries if product is not to be played with for a long time.
Do not short-circuit the supply terminals.
Should this product cause, or be affected by, local electrical
interference, move it away from other electrical equipment. Reset
(switching off and back on again or removing and re-inserting
batteries) if necessary.
RECHARGEABLE BATTERIES: Do not mix these with any other types
of batteries. Always remove from the product before recharging.
Recharge batteries under adult supervision.
iR TYPES OF BATTERIES.
+
and - polarity
DO NOT RECHARGE
"51
GE/NO
:
.......................................
TO
KNOW
Volume
TnEAMP
..............i
.
i
.
-.
,
5'
=
L;
Before you plug
amplifier
Off:
uwxplug
d 'n*o
t
.
.
,
..
,
'
--
,:J
5
-
-
~
-
*-F--...-.-.
5-
.'
,
8
.
..
;
.
-
-
.
...~
.
.
,~
-
..
.
-
~.
~!J
&I;
--+z
.:.;
.-
,
-
-,;.
-
-
4
%.
--
.
.LL
in
__I
:
-,
.
.
.?;:.?
,
&-.2
.
.
..,.=?
:-
,
.
. .
#,.'i
T.
'
anything in or out of the amplifier jacks, turn the
will
avoid a "pop" noise.
It is also very important to use the INPUT and OUTPUT
jacks correctly. Confusing them may harm the connected
electronic products.
To connect the amplifier to your POWER
Guitar
1.
2.
3.
4.
(sold
separately):
Take the cable that came with the amplifier and plug one end into
the amplifier
'IN
1"
jack.
Rug the other end of the cable into the "OUT" jack of the
Tlrrn the amplifier
ON.
May music, adjusting the amplifier volume to your liking. Setting the
volume of your .guitar too high may cause distodion in the amplifier.
If you want to use your amplifier as a speaker for your personal
music player
1.
Plug one end of the encbsed cable into the OUTPUT jack of you
personal music player (not included).
2.
Plug the other end of the cable into the 'IN
NOT insert this cable end into the amplifier's "OUT" jack!
Adjust the amplifier volume to your liking. Setting the volume
DM0
-'Y
L
f'-&
;,.
-;-
Jwl
lnot included) too high may cause distortion
(CD
player, mp3 player, etc. - not included):
(PMPJ
2"
jack
of
the amplifier. Do
in
the amplifier.
im
.
uf
your
music from your
1.
follow the instructions to connect your POWER TOURTM Electric Guitar
(sold separately) to the amplifier.
with the amplifier.
2.
Take the shorter cable, which came with your POWER TOURTM Elecmc
Guitar (sold separately). and use it to plug your personal music player
(not included) into the amplifier's 'IN
personal music player (not included) to the amplifier's 'OUT" jack!
3.
Adjust the volume settings of your personal music player (not
included), guitar (sold separately) and your amplifier to get the
appropriate balance
PMP
(not included):
of
(p.
3)
Use the long cable that came
2"
jack. Do NOT connect your
sound to jam along with your tunes.
i
CONNECTbNG
If you have a second POWER TOURTM amp (sold separately). you can c
two amplifiers. Doing so doubles your sound!
/SZA
CMNG POWER TOURmAMPS
i
Take the cable that came with the second POWER
into the "OUT" jack of the first amplifier: plug the other end of this cable into the
I!
'IN
1"
jack of the second amplifier.
Once you have the two POWER TOURTM AMPS connected, you may plac
amplifier on top of the other amplifier: you'll see that the four pads on t
of one amplifier fit comfortably into four tabs on the top of the other amplifier.
This does not lock the two amplifiers together: so
Control the tone and volume of each amp with each amplifier's Tone and ~olum&
knob. If you have two or more amps connected together, it is a good idea to set
each amp at the same volume: this equalizes the sound.
Use the Volume knob on your guitar (not included) to control guitar output. If you
kt,
ant to play loud, set each amplifier at the same high volume, then turn up the
volume of your guitar: use the Tone knobs . on each of the amps to adjust for the
best sound.
'Auto-Off' Feature
If you don't play any music through the amplifier for about
(conserving battery life, should you forget to turn the amplifier
through the amplifier. (The
loud notes.) You could also switch the power switch off, then back on again, to wake up the amplifier. If you're not
going to play through your amplifier for a while. however, it's best to turn it
amplifier might not pick up low-volume music,
be
TOURTM AMP, and plug on
careful not to knock or push them over!
15
minutes. the amplifier
off).
To wake the amp back up. play some music
so
you might have to play a couple of
off,
to conserve battery life.
-
-
will
enter a 'sleep state"
If
yDy"HWnt
twoor
1.
Connsct
to
jam
along
with
more
amps:
your personal music player
. .
:
your
.:
-L.'=-,.
-
7
-
-
"..
.
.
-
.,-
.
~
.~
...
-
-
personal
to
the guitar
.:
,,
, + -,
--
-
-,
-.
. .
music
--
,
-~
~
.
--
(sold
separately).
2.
Connect the guitar to the first amp's
3.
Connect the first amp's
4.
Control the input of your personal music player through the
OUT
Jack
'IN
1"
Jack.
to the second amp's
pbyer's volume setting.
--
'->4
,
.- ---
,
..
:?LL+€-~
.
.
-
player
IN1
jack.
:-
,..t,~
.
-
-.
with
.
,.
,
,
,
,,
..,
,
.,
.
.A.
.
I
Make sure the volume levels of the am~lifier and of vour musical device
sounds are faint or we
1
(not included) are turned up.
The amplifier is acting erra aa y Or, the batteries may need changing. See battery instructions for details
-m
I've changed the batteries, and the
am~lifier is not doina anvthina.
I
cannot fit an audio cord into the
INPUT or OUTPUT jack.
The amplifier is freezing up.
on how to change batteries.
Make sure you have installed the batteries correctly.
The jacks accept only
or adapters, combining
3.5
mm stereo audio cords. Using mono cables
left
and right audio channels, may damage
whatever device you plug into the amplifier.
Turn the amplifier
OFF,
wait a few seconds, and then turn it back
ON.
I
FCC
STATEMENT
This
eqyipkwpt
device,
proS:e&!c@~
uses
@uf&ant
and
has
been
to Part
against
exan
radiate radio frequency energy, and, if not installed and used in accordance with
tested and found to comply with the limits for a Class B digital
15
of the
FCC
Rules.
These
limits
are
designed to provide reasonable
hmful interference in a residential installation. This equipment generates,
the instructions, may cause harmful interference to radio communications. However, there is
guarantee
no
that
interference will not occur in a particular installation. If this equipment
does
cause harmful interference to radio or television reception, which can be determined by turning
the equipment off and
on,
the user is encouraged to try to correct the interference by
one
or
more of the following measures:
Reorie'rerlt or relocate the receiving antenna.
Increase the separatian between
the
equipment and the receiver.
Consult the dealer or an experienced radiW technician for hdp.
Product and
Reserved.
colors
TM
may vary. O 2007 Hasbro.
&
Q3
denote
U.S
Trademarks. Patent Pending.
All
Rights
Loading...
+ hidden pages
You need points to download manuals.
1 point = 1 manual.
You can buy points or you can get point for every manual you upload.