HASBRO Nerf N-Strike Unity Power System 2010 User Manual
LOADING AND FIRING THE SCOUT IX-3
SLIDE
DART
STORAGE
CAUTION:
Do not aim at eyes or face. TO
AVOID INJURY: Use only darts
designed for this product. Do not
modify darts or dart blasters.
AGES 8+
click
1
Pull SLIDE back until it clicks.
2
Pull the trigger to launch 1 dart.
3
BUILDING THE UNITY POWER SYSTEM™
SCOUT IX-3
LAUNCH
FRONT TRIGGER
Snap HORNET AS-6 into place. To remove the
1
HORNET AS-6, hold the TITAN AS-V1 straight,
tilt the HORNET AS-6 to the right, and pull down.
To fire the HORNET AS-6, press the front TRIGGER
Slide/snap SCOUT IX-3 onto the TACTICAL RAIL
2
on the side of the TITAN AS-V1. Cock SCOUT IX-3
by pushing it forward. Fire by pressing LAUNCH
BUTTON on the opposite side of the TITAN AS-V1.
on the TITAN AS-V1.
NOTE: Follow instructions above to arm and fire TITAN AS-V1 and HORNET AS-6 blasters when they are
combined.
BUTTON
SCOUT IX-3™
™
Be sure to read and follow all instructions carefully before using this product.
TITAN AS-V1™
© 2010 Hasbro. All Rights Reserved.
TM & ® denote U.S. Trademarks.
PATENTED U.S. Pat. Nos. 5529050, 7287526 & 7267118.
27347 PN 7072830000
Product and colors may vary.
LOADING AND FIRING THE TITAN AS-V1
AIR PRESSURE
GAUGE
SCOUT IX-3
LAUNCH BUTTON
LOADING AND FIRING THE HORNET AS-6
BLAST BUTTON
SLIDE
PUMP
1
Pump 16-20 times to pressurize.
2
3
Pull TRIGGER to launch.
4
NOTE: The TITAN AS-V1 must be held at a 45° angle or lower to function.
1
Push SLIDE all the way forward, then pull all
3
the way back to arm.
Pump 20-25 times to pressurize.
2
Pull the trigger to launch 1 dart. Every pull of
4
the TRIGGER will launch one dart.
Press one or both BLAST BUTTONS to launch
5
all darts.
Loading...