HASBRO Nerf N-Strike Raider Rapid Fire CS 35 User Manual
CLEARING A JAM
®
AGES 6+
1
If the mechanism seems stuck, try pulling
the trigger first.
3
If jammed dart is in Drum Magazine,
press Clip Release Button to unload Drum
Magazine.
5 6
2
Pull Slam Fire Handle back and open Jam
Clearing Door to remove jammed dart.
4
Press Jam Release Knob in and turn left
and right to reposition dart.
N-STRIKE
RAIDER RAPID FIRE CS-35
®
N-STRIKE Tactical Rail Accessories and the shoulder stock from the
N-STRIKE RECON CS-6™ are compatible with this blaster! You can also use
the Drum Magazine with any blaster that uses Quick Reload Clips.
CAUTION:
TO AVOID INJURY:
Do not aim at eyes or face.
Use only darts designed for this product.
Do not modify darts or dart blaster.
™
N-STRIKE RAIDER RAPID FIRE CS-35™ BLASTER
Tactical Rail
Jam Clearing Door
Drum Magazine Jam Release Knob
Stock Release
Switch
Stock
If that doesn’t work, remove darts from Drum
Magazine opening until you’ve removed the
jammed dart.
Product and colors may vary.
© 2009 Hasbro. All Rights Reserved.
TM & ® denote U.S. Trademarks.
U.S. Pat. Nos. 5529050, 7287526 and Patent Pending.
92356/923550900 Asst. P/N 6969760000
Once jam is cleared, replace Drum
Magazine and slide Slam Fire Handle
forward. This should load another dart.
NERF.COM
NERF.COM
FOR NEW PRODUCTS AND OFFERS
FOR NEW PRODUCTS AND OFFERS
Questions? Call: 1-800-327-8264
Slam Fire Handle
Drum Connector
Stock
Extender
Button
Clip Release
Button
TO ASSEMBLE:
Single-Fire Mode:
Click
1. Attach Drum Connector as shown. Be
sure Clip Release Button faces rear of
blaster.
2. Attach stock. Press Stock Extender
Button to adjust length of stock for your
arm length. To remove stock, slide
Stock Release Switch down.
3. Matching direction of dart image on
Drum, load 1 dart at a time. Drum
Magazine can hold up to
35 CLIP-SYSTEM DARTS.
NOTE: Use only CLIP-SYSTEM DARTS
with this blaster.
Using N-STRIKE RAIDER RAPID FIRE CS-35:
2
Slide Slam Fire Handle back and forward
once to load dart.
3
Pull trigger to fire.
Slam Fire Mode:
4
Hold trigger down, and rapidly slide Slam Fire Handle back and forward repeatedly.
Be sure to slide handle all the way back and all the way forward to prevent
damaging darts.
To reload:
1
Slam Fire Handle MUST be pulled all the way back for the Drum Magazine to load
properly.
5
Slide handle all the way back before
removing Drum Magazine.
NOTE: Do not store this blaster cocked and ready to fire.
6
Press Clip Release Button.
Loading...