HASBRO My Little Pony Scootaloo on the Go User Manual

™

REMOTE CONTROL

Replace with 2 x 1.5V “AA” or R6 size batteries.
Alkaline batteries recommended. Phillips/cross head
screwdriver (not included) needed to replace batteries.

1.5V AA
R6 size

x2

BATTERIES INCLUDED

SCOOTER

x3

BATTERIES REQUIRED

1.5V AA or R6 size

Alkaline batteries recommended. Phillips/cross
head screwdriver (not included) needed to
insert batteries.

NOT INCLUDED

RC Scootaloo on the Go!™

AGES 3+

GETTING

STARTED

remote scooter

The remote control is packaged in “DEMO” mode. Activate its full range of
features by moving the PLAY/OFF/ DEMO switch to the “PLAY” position.
Switch is located on the back of the remote control. The scooter’s ON/
OFF switch is located on the bottom of the scooter. Turn on the scooter
by moving the switch to the “ON” position.

TIP FOR PARENTS:

the horn button for 5 seconds or until you hear a tone. Repeat step to turn the sound
on again.

NOTE:

use battery power whenever their switches are in the “ON” position. To help conserve battery
life, move the switches to “OFF” when you’re not playing with the toy.

The LED light indicates that the scooter’s turned on. The scooter and remote control

To turn off motor sounds in PLAY mode, press and hold

PLAYING

WITH THE

TOY

Press button to

Press button to move
scooter forward

turn scooter

Press button for
scooter sounds

BATTERIES

TO INSTALL SCOOTER
BATTERIES

Use a Phillips/cross head
screwdriver (not included)
to loosen screw in battery
compartment cover (screw
remains attached to cover).
Remove cover. Insert 3 x 1.5V
“AA” or R6 size batteries.
Replace cover and tighten
screw. Alkaline batteries
recommended.

TO REPLACE REMOTE CONTROL BATTERIES

Use a Phillips/cross head screwdriver
(not included) to loosen screw in battery
compartment cover (screw remains attached
to cover). Remove cover. Remove and discard
old batteries. Replace with 2 x 1.5V “AA” or R6
size batteries. Alkaline batteries recommended.
Replace cover and tighten screw.

IMPORTANT: BATTERY INFORMATION

CAUTION:

1. Always follow the instructions carefully. Use only batteries specified
and be sure to insert them correctly by matching the + and – polarity
markings.

2. Do not mix old batteries and new batteries or standard (carbon-zinc)
with alkaline batteries.

3. Remove exhausted or dead batteries from the product.

4. Remove batteries if product is not to be played with for a long time.

5. Do not short-circuit the supply terminals.

6. Should this product cause, or be affected by, local electrical
interference, move it away from other electrical equipment. Reset
(switching off and back on again or removing and re-inserting
batteries) if necessary.

7. RECHARGEABLE BATTERIES: Do not mix these with any other types of
batteries. Always remove from the product before recharging. Recharge
batteries under adult supervision. DO NOT RECHARGE OTHER TYPES OF
BATTERIES.

TROUBLESHOOTING

If your scooter does not respond, please switch OFF and back ON again or
replace the batteries in the scooter and remote control.

FCC STATEMENT

This device complies with part 15 of the FCC Rules. Operation is subject to the following two
conditions: (1) This device may not cause harmful interference, and (2) this device must accept
any interference received, including interference that may cause undesired operation.

This equipment has been tested and found to comply with the limits for a Class B digital
device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable
protection against harmful interference in a residential installation. This equipment generates,
uses and can radiate radio frequency energy, and, if not installed and used in accordance with
the instructions, may cause harmful interference to radio communications. However, there is
no guarantee that interference will not occur in a particular installation. If this equipment does
cause harmful interference to radio or television reception, which can be determined by turning
the equipment off and on, the user is encouraged to try to correct the interference by one or
more of the following measures:

- Reorient or relocate the receiving antenna.

- Increase the separation between the equipment and the receiver.

- Consult the dealer or an experienced radio/TV technician for help.

CAUTION: Changes or modifications not expressly approved by the party responsible for
compliance could void the user’s authority to operate the equipment.

Product and colors may vary.

© 2009 Hasbro. All Rights Reserved.

TM & ® denote U.S Trademarks.

640680790

PN 6954150000

Questions? Call 1-800-327-8264