
MyLittlePony.com 
MyLittlePony.com 
Visit 
Questions? Call 1-800-327-8264
x3
BATTERIES INCLUDED
Replace with 3 x 1.5V “AAA” or LR03 size alkaline 
batteries . Phillips/cross head screwdriver (not included) 
needed to replace batteries.
Note: RAINBOW DASH is packaged in “DEMO” 
mode. When you bring her home, activate her full 
range of features by moving the PLAY/DEMO 
62320/62319 Asst.
62321/62319 Asst.
AGES 3+
switch to the “PLAY” position.
™
So Soft Newborn™
Thank you for purchasing this My Little Pony® toy! For maximum play 
value, please read and follow instructions carefully.
TO REPLACE BATTERIES
Use a Phillips/cross head screwdriver (not included) to loosen screw in 
battery compartment door (screw remains attached to door). Remove 
door and remove old batteries. Insert 3 x 1.5V “AAA” or R03 size batteries. 
Alkaline batteries recommended. Replace door and tighten screw.
Rainbow Dash®
Rock pony in your arms, or press her 
foot — she talks, sings and makes 
baby sounds! Includes pony figure 
and pacifier.
© 2006 Hasbro. All Rights Reserved. 
TM and ® denote U.S. Trademarks. 
62320/62319 Asst. 
62321/62319 Asst. PN 6614690000
Pinkie Pie®
“Feed” pony her bottle, or press her 
foot — she talks, sings and makes 
baby sounds! Includes pony figure 
and bottle.

CAUTION: 
1. As with all small batteries, the batteries used with this toy should 
be kept away from small children who still put things in their 
mouths. If they are swallowed, promptly see a doctor and have the 
doctor phone (202) 625-3333 collect. In other countries, have the 
doctor call your local poison control center.      
2. Make sure the batteries are inserted correctly and always follow the 
toy and battery manufacturer’s instructions.
3. Do not mix old and new batteries, alkaline, standard (carbon-zinc) 
or rechargeable (nickel-cadmium) batteries. 
IMPORTANT: BATTERY INFORMATION
Please retain this information for future reference. 
Batteries should be replaced by an adult.
CAUTION:
1. Always follow the instructions carefully. Use only batteries specified and be 
sure to insert item correctly by matching the + and – polarity markings.
2. Do not mix old batteries and new batteries or standard (carbon-zinc) with 
alkaline batteries.
3. Remove exhausted or dead batteries from the product.
4. Remove batteries if product is not to be played with for a long time.
5. Do not short-circuit the supply terminals.
6. Should this product cause, or be affected by, local electrical interference, 
move it away from other electrical equipment. Reset (switching off and back 
on again or removing and re-inserting batteries) if necessary.
7. 
RECHARGEABLE BATTERIES: Do not mix these with any other types of batteries. 
Always remove from the product before recharging. Recharge batteries under 
adult supervision. DO NOT RECHARGE OTHER TYPES OF BATTERIES.
8. As with all small items, these batteries should be kept away from children. If 
swallowed, seek medical attention immediately.
FCC Statement
This device complies with part 15 of the FCC Rules. Operation is subject to the following 
two conditions: (1) This device may not cause harmful interference, and (2) this device must 
accept any interference received, including interference that may cause undesired operation. 
This equipment has been tested and found to comply with the limits for a Class B digital 
device, pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable 
protection against harmful interference in a residential installation. This equipment generates, 
uses and can radiate radio frequency energy, and, if not installed and used in accordance with 
the instructions, may cause harmful interference to radio communications. However, there is 
no guarantee that interference will not occur in a particular installation. If this equipment does 
cause harmful interference to radio or television reception, which can be determined by turning 
the equipment off and on, the user is encouraged to try to correct the interference by one or 
more of the following measures:
• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and receiver.
• Consult the dealer or an experienced radio/TV technician for help.