Hasbro Lazer Tag User Manual

LT01_distressed

AGES 8+

Replace with 12 x 1.5V “AA” or R6 size alkaline batteries.
Phillips/cross head screwdriver (not included) needed to
replace batteries.

BATTERIES INCLUDED

x12

®

13744

STANDARD, CRT TV ONLY. NOT FOR USE WITH PROJECTION, LCD,

HIGH-DEFINITION, OR PLASMA TV.

Replacing the batteries:

1. Using a Phillips/cross head screwdriver (not

included), unscrew the battery covers on
your Tagger units.

2. Insert 6 fresh 1.5 V “AA” or R6 size

batteries (not included) in each Tagger
unit. Alkaline batteries recommended. See
diagram for polarity.

3. Replace battery covers and tighten screws.

1

CAUTION: TO AVOID BATTERY LEAKAGE

1. Be sure to insert the batteries correctly and always follow the toy and battery
manufacturers’ instructions;

2. Do not mix old and new batteries or alkaline, standard (carbon-zinc) or
rechargeable (nickel-cadmium) batteries;

3. Always remove weak or dead batteries from the product.

IMPORTANT: BATTERY INFORMATION

Please retain this information for future reference.
Batteries should be replaced by an adult.

CAUTION:

1. Always follow the instructions carefully. Use only batteries specified and be sure

to insert item correctly by matching the + and – polarity markings.

2. Do not mix old and new batteries or standard (carbon-zinc) with alkaline

batteries.

3. Remove exhausted or dead batteries from the product.

4. Remove batteries if product is not to be played with for a long time.

5. Do not short-circuit the supply terminals.

6. Should this product cause, or be affected by, local electrical interference, move

it away from other electrical equipment. Reset (switching off and back on again
or removing and reinserting batteries) if necessary.

7. RECHARGEABLE BATTERIES: Do not mix these with any other types of

batteries. Always remove from the product before recharging. Recharge batteries
under adult supervision. DO NOT RECHARGE OTHER TYPES OF BATTERIES.

12

THE PARTS OF YOUR TAGGER

Accessory Rail

Power/Game

Type Switch

Trigger

Shield Activation

Button

Strength Switch

Receiver Dome/Hit Indicator

Indoor/Outdoor Switch

Weapon Rail

Strength

Gauge

Ammo Core™*

Release

Ammo Core™*

13

Ammo

Indicator

VIDEO GAME MODULE

PINPOINT SIGHT

SHOT BLAST™*

Attachment

Rack

Release Button

BEFORE YOU TURN ON YOUR TAGGER

1. All players should agree on Strength scores for the

game, and set the Strength Switch to either 10 or

25. You can’t change your Strength score once the
game begins!

• 10 Strength means you can be tagged 10 times
before you are out of the game.

• 25 Strength means you can be tagged 25 times
before you are out of the game. Your Strength

Gauge will stay filled until you are on your last 10

Strength points.

2. Set the Indoor/Outdoor Switch to the proper

position based on where you are.

3. Decide what game type to play – Solo or Team.

• Solo Game means that all players are on their
own. The last player with any Strength Points left
wins!

• Team Game means that players organize
themselves into two teams that battle against each
other. You can’t tag someone on your own team.
There are many different team games you can play
– make up your own, or check out lazertag.com for
team game rules!

14