Hasbro Hitclips Micro Audio Pen User Manual

Micro Audio Pen

Instruction

Ages 5 & Up Item No. 59946

We hope you enjoy your new

HitClips™ Pen it's a functioning

pen as well as a portable

Micro Music Player!

Battery Installation

1. Unscrew battery door. (see diagram)

2. Remove used batteries and dispose of properly.

3. Insert 3 new LR44/G13A batteries.

4. Replace batteries door and tighten screw.

Includes:

Pen HitClips™ Micro Music Clip Earbud

1. Play/stop button

2. Volume control switch

3. Earbud plug-in

To play a HitClips™

To play a HitClips™ Micro Music Clip

Carefully insert the HitClips™ chip

Micro Music Clip:

into the slot. Plug the earbud into the earbud jack. Play and stop by pressing the Play/Stop button. Adjust the volume by using the Volume Control switch (low and high).

Replace pen refill

Rotate the pen tip at counter clockwise direction.

2. Pull out the pen tip.

3. Take out the pen refill with compression spring.

4. Replace the pen refill.

5. Install it with spring inside housing.

6. Snap the pen tip back into housing.

7. Push up the cap to open and turn the cap clockwise for writing.

To ensure proper function

• Do not mix old and new batteries.

• Do not mix alkaline, standard (carbon zinc), or rechargeable batteries (nickel-cadmium).

• Batteries installation should be done by an adult. Non-rechargeable batteries are not to be recharged.

•

• Rechargeable batteries are to be removed from the toy before being recharged (if removable).

• Rechargeable batteries are only to be recharged under adult supervision (if removable)

• Only batteries of the same or equivalent type as recommended are to be used.

• Batteries are to be inserted with correct polarity.

• Exhausted batteries are to be removed from the toy.

• The supply terminals are not to be short-circuited.

• Do not dispose of batteries in fire, batteries may explode or leak.

90-Day Limited Warranty

FCC Statement

Tiger Electronics (Tiger) warrants to the original consumer purchaser of this product that the product will be free from defects in materials or workmanship for 90 days from the date of original purchase. This warranty does not cover damages resulting from accident, negligence, improper service or use or other causes not arising out of defects in materials or workmanship.

During this 90-day warranty period, the product will either be repaired or replaced (at Tiger's option) without charge to the purchaser, when returned with proof of the date of purchase to either the dealer or to Tiger.

Product returned to Tiger without proof of the date of purchase or after the 90-day warranty period has expired, but prior to one year from the original date of purchase, will be repaired or replaced (at Tiger's option) for a service fee of U.S. $9.00. Payments must be by check or money order payable to Tiger Electronics.

The foregoing states the purchaser's sole and exclusive remedy for any breach of warranty with respect to the product.

All product returned must be shipped prepaid and insured for loss or damage to:

Tiger Repair Department

1000 N. Butterfield Road, Unit 1023

Vernon Hills, IL 60061, USA

The product should be carefully packed in the original box or other packing materials sufficient to avoid damage during shipment. Include a complete written description of the defect, a check if product is beyond the 90-day warranty period, and your printed name, address and telephone number.

THIS WARRANTY IS IN LIEU OF ALL OTHER WARRANTIES AN D NO OTHER REPRESENTATIONS OR CLAIMS OF ANY NATURE SHALL BE BINDING ON OR OBLIGATE TIGER IN ANY WAY. ANY IMPLIED WARRANTIES APPLICABLE TO THI S PRODUCT, INCLUDING WARRANTIES OF MERCHANTABILITY AND FITNESS FOR A PARTICULAR PURPOSE, ARE LIMITED TO THE NINETY (90) DAY PERIOD DESCRIBED ABOVE. IN NO EVENT WILL TIGER BE LIABLE FOR ANY SPECIAL, INCIDENTAL, OR CONSEQUENTIAL DAMAGES RESULTING FROM POSSESSION, USE, OR MALFUNCTION OF THIS PRODUCT.

Some states do not allow limitations as to how long an implied warranty lasts and/or exclusions or limitations of incidental or consequential damages, so the above limitations and/or exclusions of liability may not apply to you. This warranty gives you specific rights, and you may also have other rights, which vary, from state to state.

This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions:

(1) This device may not cause harmful

interference, and

(2) This device must accept any interference

received, including interference that may cause undesired operation.

Warning: Changes or modifications to this unit not expressly approved by the party responsible for compliance could void the user's authority to operate the equipment.

NOTE: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and , if not installed and used in accordance with the instructions, may cause harmful interference to radio communications.

However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:

- Reorient or relocate the receiving antenna.

- Increase the separation between the equipment and receiver.

- Connect the equipment into an outlet on a circuit different from that to which the receiver is needed.

- Consult the dealer or an experienced radio/TV technician for help.

For more information about Tiger Electronics, our products and special promotions, please visit our web site at:

www.tigertoys.com

Please retain instructions for future reference.

A division of Hasbro, Inc.

Where Technology Comes to Play!

PRINTED IN CHINA

™

200104790IWTI-01