
FCC STATEMENT
This device complies with part 15 of the FCC Rules.
Operation is subject to the following two conditions:
(1) This device may not cause harmful interference, and
(2) this device must accept any interference received,
including interference that may cause undesired operation.
This equipment has been tested and found to comply with
the limits for a Class B digital device, pursuant to part 15
of the FCC Rules. These limits are designed to provide
reasonable protection against harmful interference in a
residential installation. This equipment generates, uses and
can radiate radio frequency energy, and, if not installed
and used in accordance with the instructions, may cause
harmful interference to radio communications. However,
there is no guarantee that interference will not occur in a
particular installation. If this equipment does cause harmful
interference to radio or television reception, which can be
determined by turning the equipment off and on, the user is
encouraged to try to correct the interference by one or more
of the following measures:
• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and the
receiver.
• Consult the dealer or an experienced radio/TV technician
for help.
CAUTION: Changes or modications to this unit not
expressly approved by the party responsible for compliance
could void the user’s authority to operate the equipment.
Questions? Call 1-800-844-3733
Product and colors may vary.
© 2010 Hasbro. All Rights Reserved.
TM & ® denote U.S. Trademarks.
U.S. Pat. No. 6811461.
26912 Asst. PN 7146900000
AGES 4+
GoGo’s Walkin’ Puppies
Puppy colors may vary.
TM
CARE
CARE
GUIDE
GUIDE

x3
BATTERIES INCLUDED
Replace with 3 x 1.5V “AA” or LR6 size alkaline
batteries. Phillips/cross head screwdriver (not
included) needed to replace batteries.
Getting to
Know Your Pet
Back sensor
When you pet your toy puppy on
his back, he really responds to
your touch!
The switch is currently in TRY ME position.
Please slide to ON position to activate your toy’s
play features.
ON
TRY ME OFF
TRY ME/OFF/ON
Switch and battery
door on tummy.
A sensor is a part of the toy
that responds to your touch!
1 2

How to Play
To activate your toy puppy,
slide the TRY ME/OFF/ON
ON
TRY ME OFF
Walking Mode
For walking action, position your puppy’s front
legs downward as shown.
When you pet his back, your toy puppy responds
to your touch by walking around in circles. After
a few seconds, he’ll stop for more petting and
encouragement, then he’ll start walking again.
switch on puppy’s tummy to
the ON position. Your puppy
is now ready to play!
Calm Mode
If you press and hold down your toy puppy’s back
for about a second, he’ll make calm sounds and
stop walking. When you pet him, he’ll respond
with more calm puppy sounds.
If you stop petting your puppy for about a minute,
he’ll go into Sleep Mode.
Sleep Mode
If you stop petting your toy puppy for about a
minute, he’ll go to “sleep” and won’t move or
make any sounds. You can “wake” him up again
and return to Walking Mode by petting his back!
NOTE: This toy uses battery power whenever
its switch is in the ON position. When you’re not
playing with the toy, move its switch to the OFF
position to help conserve battery life.
Grooming
Your Pet
Just like a real puppy, your toy puppy likes to stay
clean. But make sure he doesn’t get wet! Gently
brush his fur with a cloth or soft brush to loosen
any dirt. You can use a slightly damp cloth to
remove stains, but don’t use any cleaners on your
toy puppy.
43

Troubleshooting
If your pet doesn’t seem to respond properly,
rst try sliding the TRY ME/OFF/ON switch to
OFF, then back to ON. If that doesn’t work, you
may need to replace the batteries.
To Replace
Batteries
1. Locate battery
compartment on
puppy’s tummy.
2. Loosen screw on
battery door.
3. Remove and discard
old batteries.
4. Replace with fresh
3 x 1.5V “AA” or
LR6 size alkaline
batteries.
5. Replace door and
tighten screw.
IMPORTANT: BATTERY INFORMATION
CAUTION:
1. Always follow the instructions carefully. Use only
batteries specified and be sure to insert them
correctly by matching the + and – polarity markings.
2. Do not mix old batteries and new batteries or
standard (carbon-zinc) with alkaline batteries.
3. Remove exhausted or dead batteries from the
product.
4. Remove batteries if product is not to be played with
for a long time.
5. Do not short-circuit the supply terminals.
6. Should this product cause, or be affected by, local
electrical interference, move it away from other
electrical equipment. Reset (switching off and back
on again or removing and re-inserting batteries) if
necessary.
7. RECHARGEABLE BATTERIES: Do not mix these with
any other types of batteries. Always remove from the
product before recharging. Recharge batteries under
adult supervision. DO NOT RECHARGE OTHER TYPES
OF BATTERIES.
NOTE TO UK CONSUMERS: This product and its
batteries must be disposed of separately at your
local waste recycling centre. Do not dispose of in
your household waste bin.
65