FurRealfriends.com
FurRealfriends.com
Questions?
Call 1-800-327-8264
x6
BATTERIES
ALKALINE
REQUIRED
1.5V D or LR20 size
Phillips/cross head screwdriver (not included)
needed to insert batteries.
NOT INCLUDED
CAUTION:
Keep small parts necessary for
assembly out of children’s reach.
TO REATTACH HALTER
1. The
assembled
2. Turn halter over with
the buckle underneath.
halter looks
like this.
1a. Buckle
this part of
halter.
FCC STATEMENT
This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions: (1)
This device may not cause harmful interference, and (2) this device must accept any interference received,
including interference that may cause undesired operation. This equipment has been tested and found
to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC Rules. These limits
are designed to provide reasonable protection against harmful interference in a residential installation.
This equipment generates, uses and can radiate radio frequency energy, and, if not installed and used in
accordance with the instructions, may cause harmful interference to radio communications. However, there
is no guarantee that interference will not occur in a particular installation. If this equipment does cause
harmful interference to radio or television reception, which can be determined by turning the equipment off
and on, the user is encouraged to try to correct the interference by one or more of the following measures:
• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and receiver.
• Consult the dealer or an experienced radio/TV technician for help.
3. Place halter over
pony’s muzzle as
shown.
4. Buckle behind the
pony’s ears (using
second or third hole).
AGES 4+
76471
ADULT ASSEMBLY REQUIRED.
Tool needed: Phillips/cross
head screwdriver (not included).
®
Pony Care Guide
Thank you for purchasing this FURREAL
FRIENDS® toy! Be sure to read and follow
instructions carefully, so you and your pony
can have lots of fun together! Remember,
BUTTERSCOTCH® is like a real pony in many
ways. The more you take care of her and love
her, the happier she’ll be!
Pony comes with carrot, brush, halter and
special adoption certificate.
For indoor use only.
© 2006 Hasbro. All Rights Reserved.
TM & ® denote U.S. Trademarks.
U.S. Pat. No. 6811461 and Patents Pending
76471 PN 6686530000
MAXIMUM WEIGHT 80lbs/36kg
ASSEMBLY
“RIDING” YOUR PONY
GROOMING YOUR PONY
Head
Watch an
assembly demo
online at www.
furrealfriends.com!
For questions on
assembly,
call Hasbro
Consumer Affairs
at 1-800-327-8264.
Body
Step 1
Head
Turning
Mechanism
Body
Pull back head plush. Snap
head onto body.
STEP 1A - VERY
IMPORTANT – this step
helps ensure that your pony’s head
and neck have adequate support.
Head
Step 3
front
Clip
side
faces
front
of
pony.
Snap in electrical connector
clip from head into body.
Make sure clip side of
connector faces toward
front of pony
.
1 6
Step 1a
Fasten screw
to left side of
head-turning
mechanism.
Step 4
A. Zip head and
body plush
together.
Note
To unfasten zipper,
press button on
zipper clip to release.
Step 2
Fasten 2 screws onto the
top of the head-turning
mechanism.
B. Snap zipper pull
into clip at end
of zipper.
Your pony can tell when you’re sitting on her to
have a “ride”! When you sit on your pony, she will
move her head up and down, blink her eyes and
twitch her ears while making soft sounds.
Wait for your pony to stop moving before you take
her into “riding mode.”
When sitting on your pony, tap her hindquarters
with your hand and she’ll go into “riding mode”.
She will make walking sounds and also move her
eyes, ears and head. After a few seconds, she’ll
stop. Just tap her hindquarters to get her
going again!
Tap
hindquarters
Note: If you
have any
concerns or
questions
about this toy,
please do not
return it to the
store. Instead,
call Hasbro
Consumer
Affairs at
1-800-327-8264
for expert advice
and answers.
Brush your pony with her special
grooming brush to keep her coat
healthy.
To clean your pony, gently brush
her with a cloth or soft brush to loosen any dirt.
Then use a slightly damp cloth to remove stains.
• To prevent staining, wipe off dirt immediately.
• Do not get wet; to remove stains use only a
slightly damp cloth.
• Do not use detergent or stain removers.
• If pony gets wet, remove batteries and let dry;
once pony is completely dry, replace batteries.
• Avoid spilling food or beverages on the pony.
• Do not throw or kick the pony, and do not push
sharp objects through the speaker openings.
• Do not leave pony in direct sunlight; high
temperatures will destroy the mechanism.