Hasbro 63599 Instructions Manual

®

Thank you for purchasing this
MY LITTLE PONY® product!
Please read these instructions
carefully, to ensure proper
use of the toy.

AGES 3+

Ring-A-Pony
Cell Phone™

63599

BATTERIES
INCLUDED

x3

1.5V AAA or R03 size

Replace with 3 x 1.5V “AAA”
or R03 size batteries.
Alkaline batteries recommended.
Phillips/cross head screwdriver
(not included) needed to
replace batteries.

GETTING TO KNOW YOUR TOY PHONE

PLAYING WITH THE TOY PHONE

LED display (3)

If you want to receive a call from a pony, press the Ring Button to
make the phone ring! When you open the phone, you will hear either
RAINBOW DASH® pony, PINKIE PIE® pony, or SWEETIE BELLE™
pony start a conversation with you.

OR, if you want to call a pony on the phone, open the phone, and

press any seven numbers. A pony will start a conversation with you.

OR, if you want to talk to a particular pony, press that pony’s “Speed

Dial” button.

OR, if you want to talk to all three ponies at once, press the “Party

Line” button, shaped like a heart.

• When a pony is speaking, you will see its LED display light up!

• While the phone is open, pretend to use the phone as a camera:
press the Ring Button and hear the phone “click”!

• Close the phone to end any conversation.

Ring Button/
Toy Camera

Numbered Keys

“Speed Dial” buttons (3)

“Party Line” button

NOTE TO CONSUMER: This toy comes
packaged in “TRY-ME” mode. When you
take the toy out of its box, press one of the
“Speed Dial” buttons: this takes the toy out
of “TRY-ME” mode and lowers its volume.

CAUTION

1. As with all small batteries, the batteries used with this toy should be

kept away from small children who still put things in their mouths.
If they are swallowed, promptly see a doctor and have the doctor
phone [phone] collect. In other countries, have the doctor
call your local poison control center.

2. Make sure the batteries are inserted correctly and always follow the

toy and battery manufacturer’s instructions.

3. Do not mix old and new batteries, alkaline, standard (carbon-zinc) or

rechargeable (nickel-cadmium) batteries.

IMPORTANT: BATTERY INFORMATION

Please retain this information for future reference.
Batteries should be replaced by an adult.

CAUTION:

1. Always follow the instructions carefully. Use only batteries specified and

be sure to insert item correctly by matching the + and – polarity markings.

2. Do not mix old batteries and new batteries or standard (carbon-zinc) with

alkaline batteries.

3. Remove exhausted or dead batteries from the product.

4. Remove batteries if product is not to be played with for a long time.

5. Do not short-circuit the supply terminals.

6. Should this product cause, or be affected by, local electrical interference,

move it away from other electrical equipment. Reinsert batteries if
necessary.

7. RECHARGEABLE BATTERIES: Do not mix these with any other types of

batteries. Always remove from the product before recharging. Recharge
batteries under adult supervision. DO NOT RECHARGE OTHER TYPES OF
BATTERIES.

8. As with all small items, these batteries should be kept away from children.

If swallowed, seek medical attention immediately.

TO REPLACE BATTERIES

Using a Phillips/cross head screwdriver,
loosen screw in battery compartment
cover (screw stays attached to cover).
Replace with 3 x 1.5V “AAA” or R03
size batteries (not included). Alkaline
batteries recommended. Replace cover
and tighten screw.

MyLittlePony.co m

MyLittlePony.co m

Visi t

Questions? Call 1-800-327-8264

© 2007 Hasbro. All Rights Reserved.
TM & ® denote U.S Trademarks.

63599 PN 6735270000

Product and colors may vary.

FCC STATEMENT
This device complies with part 15 of the FCC Rules. Operation is subject to the following two
conditions: (1) This device may not cause harmful interference, and (2) this device must accept
any interference received, including interference that may cause undesired operation.

This equipment has been tested and found to comply with the limits for a Class B digital device,
pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protec­tion against harmful interference in a residential installation. This equipment generates, uses and
can radiate radio frequency energy, and, if not installed and used in accordance with the instruc­tions, may cause harmful interference to radio communications. However, there is no guarantee
that interference will not occur in a particular installation. If this equipment does cause harmful
interference to radio or television reception, which can be determined by turning the equipment
off and on, the user is encouraged to try to correct the interference by one or more of the follow­ing measures:

- Reorient or relocate the receiving antenna.

- Increase the separation between the equipment and the receiver.

- Consult the dealer or an experienced radio/TV technician for help.